Search results for query: *

  • Users: Knebel
  • Content: Threads
  • Order by date
  1. Knebel

    Dual pass radiator vs standart

    I am looking to see if anyone has info on how much better a dual pass radiator might cool. I currently have a 22" aluminium radiator made by champion. It was rated for up to 350hp and has 2 "1inch" cores. I think this one is borderline for my combo in the summer with AC.... How would a dual...
  2. Knebel

    Anyone here running a Fitech or has deep knowledge of EFI?

    Having some EFI trouble, tech support non existent. Anyone has some knowledge on EFI system? Pretty much the system gets stuck in open loop randomly, thats how it started. The o2 showed normal values but the fuel trim just...stopped. Reflashed the software a few times and every time I do it...
  3. Knebel

    Funny Story about Grounds.

    The other day I was getting rid of some unused wires from previous projects in my engine bay. In the process, I had to unravel a lot of electric tape and i noticed that in one of the (original looking looms) was a wire that was just open ended. I didnt think much kf it because the wiring was a...
  4. Knebel

    Does this sound like a manifold gasket leak?

    Hello, Had just installed some headers and the drivers side is fine and makes almost 0 noise. The passenger however has a real loud tick. The ball connector seems fine and I cant find any carbon tracing. Does this sound like its the manifold gasket? I used the cheap ones that came with the...
  5. Knebel

    Shaking 360 LA

    Hey, I need some guidance on what could cause my 360 to shake pretty decent at idle. Its the same in gear or park and sort of new ish. The engine always had a little shake but not like that. Two things, I am running efi and have tried to adjust the idle to the most stable solid vacuum and such...
  6. Knebel

    Aftermarket Bucket seats because of medical reasons..?

    Hey all. I'm hesitant to ask but does anyone know of some decent buckets/racing seats that will keep your lower half planted in the seat with minimal body twisting and such? I had an accident and have arthritis in my lower back now at only 37 and I have a newly upholstered metallic red/maroon...
  7. Knebel

    195 better than 180 in my Vehicle?

    Hey all, I am trying to sort out some little things on my car before I can list it for sale :(. Cant enjoy it as much because of a back injury, it really really sucks. However, I am trying to figure something out with my cooling before. I have replaced my one 16" Spal with a decent shroud and...
  8. Knebel

    Question about misfire, gas on plug

    Hey all, I am running an efi on my 360. Replaced the plugs yesterday and for some reason cylinder 8 was wet. The plug looked a little darker than the others but not substentially different enough and I run a CDI ignition. I'm thinking it might have been oil from a valve cover leak but I have...
  9. Knebel

    Trying to figure out what my car is worth

    I have a 1968 plymouth fury III. 2 door hardtop. It is modified and not original so not for the purists (please move on I was not intending to sell the car but might be forced to). I am trying to figure out what its worth. Before I start with pics that everyone will probably pick apart lol...
  10. Knebel

    Broken flexplate or convertor?

    My Fury has started with a decent rattle sound at idle that has been getting a little more consistent today after some WOT tests from stop in a parkinglot.. I have had some starter kickbacks after installing a multispark and it now makes the same rattle sound when cranking. Happens more in N and...
  11. Knebel

    Electric fan recommendations?

    Hello, I am running a 360 with and EFI system that runs timing control too. I have a spal 2000cfm fan and Never really had a temp issue. I added an AC last winter and today was my first real day using it in 95° weater. No temp creep or heating up while driving, stays close to 200° but when I...
  12. Knebel

    Disc brake booster question

    I just finished my 4 wheel disc install and just adjusted the prop valve to the rear as good as I could. I started with it being about half way and then slowly gave the rears more pressure. So far it can really put your face in the dash when stepping on it! What a massive improvement over the...
  13. Knebel

    Master Cylinder for Disc/Disc conversion?

    What kind of master cylinder would I need for a disc setup front and rear? Will I need a residual pressure valve for the rear and a proportioning valve too? I have manual drums and will keep it manual just with discs all around. Got a very good deal where the rear brake was essentially free...
  14. Knebel

    Brake Pedal Ratio?

    I have an odd thing here. I have a 68 fury iii with manual drums all around. I contacted wilwood in regards to their disc brakes and master cylinders and got a questionaire back asking to measure the pedal ratio. I did that roughly as good as I could in the car and get a ratio of 4.5:1 This...
  15. Knebel

    Lower control arm bushing size?

    Is there Anyone who's got access to those lower control arm bushings and could give me some measurements? I would need the ID of the inner hole for the pivot pin (or the od of the pivot pin that goes into the bushing. ID of the outer metal sleeve and leght of the bushing. Looking to have some...
  16. Knebel

    Smallblock headers

    Is anyone aware of smallblock headers for a c body?
  17. Knebel

    For Sale 68 Fury III instrument cluster

    I have for sale an instrument cluster from my 68 fury. The clock does not work/worked intermittenly. $200 obo plus shipping See pics.
  18. Knebel

    Emergency Flasher question

    I have just installed my custom gauges and I have an issue with my Hazards. Its all wired pretty simply, all gauges and gauge lights share the same ground and power. Then I have a led for brights (which works just fine). And an LED for the parking brake. This one is seperate power and ground...
  19. Knebel

    For Sale Pertronix flamethrower Coil

    Not using this one anymore and its just been sitting on the shelf. 30$ plus shipping! SOLD!
  20. Knebel

    For Sale Adjustable voltage regulator

    Adjustable voltage regulator, works fine! 20 plus shipping
Back
Top