Search results for query: *

Thanks - pot metal is really pitted. I have come across them - but the seller, is often not positive of what they came out of..... I have another set - slightly less rough - but they have two different casting numbers 2664441 LH (Drivers) 2664440 RH (Pass)

Hi, I am looking for replacement vent windows for my 1968 Chrysler 2 Door fast top. By parts book – it looks like the part should be 2860696 - 7 The part number on the castings 2860705 LH (Drivers) 2860704 RH (Pass), I can’t seem to find this number in parts catalog. I realize a casting number...

I did not through the floor.. I made a nut assy and welded into the upper rail - so tube is linked together. Going thru the stiffening ribs - might work (forget where they lay across) Straight thru the floor sheet metal, i would back up with a plate in interior.

Hello, Looking for '68 speed servo, 2 vacuum line unit. I have a NOS - 29512272 - willing consider as a trade, or just buy from you Here is what I am looking for: If anyone has Part No. - I would appreciate it Thank You

I started my work carreer for the company named Blactsone Corp. with Chrysler as its major customer, for decades. To test units before shipment we typically tested at 20 psi air under water. Anything bigger than a champange bubble was a no go. As others said well - will it take 16 psi...

I used many of the threads on this site, as inspiration for my version of sub frame connectors. My Goal(s) Stiffen the car, used the connectors to lift the car if needed Use and Maintain the factory bolt location in the sub frame Once all is proven to work well - a couple of strategic welds...

I have just installed TTI with 3" collector- full length in a '68 Newport. Instructions are detailed. Pulled both torsion bars + Pass side had to undue motor mounts and lift motor. Put both in from top and feed down to tranny. Used new motor mounts. On Pass side - one header tube is...

Hope this helps, these are the screws you need to get at laying on your back (pull seats) This will separate the die cast portion of dash from filler panel. However, not the easiest way to do it. Good Luck

Dash Removal I pulled the windshield, there is 6 bolts that hold the filler panel to the balance of dash. With what you already pulled it should come out as an assembly. Be prepared, the whole thing weighs 78 pounds. (I have done 2 dashes like this) If you leave windshield, you might...