Bill ward
Member
Can someone please advise me the best way to remove my truck led 1968 fury.
Take the four bolts out & slid it off the hinges. Easy. The putting it back on is a bit hard.Can someone please advise me the best way to remove my truck led 1968 fury.
^This^Take the four bolts out & slid it off the hinges. Easy. The putting it back on is a bit hard.
Just unplug the harness.Good advice thank you, I did notice wires to tail lights runs inside lid. Looks like that might be fun threading them back through.
When you pull them out, attach another wire or string to the end, then leave that wire in the lid and use it to pull the tail light wires back through when you put it back together.Good advice thank you, I did notice wires to tail lights runs inside lid. Looks like that might be fun threading them back through.
I have done that. I drilled a hole that a small finish nail fit into perfectly.A couple "gauge holes" drilled near the bolts can aid in re-aligning when you replace the lid. Try smmething like eighth inch. LC