66 Monaco 500 365's latest activity
-
66 Monaco 500 365 replied to the thread Rebel performance poly intake.I put a Weiand intake on my 1960 Phoenix dart 318 4bbl, it killed low end torque. I put the factory 4bbl manifold back on it, and it was... -
66 Monaco 500 365 replied to the thread 1967 autopilot (cruise control) dash control - Imperial swap into Monaco?.I've found it way easier to retrofit a '70s cruise control. You need the cruise control unit, the throttle linkage add on, the cable...
-
66 Monaco 500 365 replied to the thread 318 poly to a 383.On a '66, the input shaft is the same as late model, I don't have experience with push button trans, (65 and older)
-
66 Monaco 500 365 replied to the thread FUEL ISSUES WITH MY 65 Chrysler Newport 383.It could be a hole in a line, that will let air in, but not drip. My friend had this happen. My $.02
-
66 Monaco 500 365 replied to the thread 318 poly to a 383.Just swap the stater support in the front pump to the '67 up, and it will fit a newer converter. I do this to every '66 I work on
-
66 Monaco 500 365 replied to the thread 318 poly to a 383.the small block (first gen HEMI, Polly and LA) and big block have different bell housings.
-
66 Monaco 500 365 replied to the thread 318 poly to a 383.short answer:Trans, exhaust, radiator and motor mounts It may need stiffer torsion bars too.
-
66 Monaco 500 365 replied to the thread The new motor is is done. Whaddya think?.Buy stock in Goodyear It will convert rubber to smoke very efficiently! looks really great
-
66 Monaco 500 365 replied to the thread What are you working on today??.Finally reassembling the '66 500's front suspension. After misplacing the lower control arm nut and panicking, I found it today. The T...
-
66 Monaco 500 365 reacted to MoPar~Man's post in the thread Lower control arm bushing install with .Here's a photo of a refurbished LCA with new bushing, and an un-touched original:
-
66 Monaco 500 365 reacted to Davea Lux's post in the thread Lower control arm bushing install with .Look at the backside of the LCA, the stud should be inserted in the round hole at the back of the hex fitting until it is flush with the...
-
66 Monaco 500 365 replied to the thread Lower control arm bushing install.That's awesome, thanks to both of you. My old guy brain over reacted, it looks like I'm good. Thanks again!
-
66 Monaco 500 365 posted the thread Lower control arm bushing install in Brakes, Suspension, Rims and Tires.H all, I finally have a press so I did my LCA bushings on my '66 Monaco. I started to install the LCA today and it didn't look right...
-
-
66 Monaco 500 365 replied to the thread AVS2 upgrade.Maybe your vacuum advance was on a full time vacuum port and now it is on a timed port, making the idle timing lower that it was...
