Thanks for that! I talked to JC Restoration a while back and never bothered to discuss the spacers. I really appreciate you sharing a need already being met. That’s a great price. I maybe need to find a non-US based, non-aerospace casting supplier.
I imagine there's wider interest in these applied to 'hot rods' and other Mopars but thought I'd start with more of a purist crowd here. I'll contact the 59-61 Forward Look and 300 crowd even though long rams are individual runners. Intake flange spacers are the same.
I'm looking to reverse...
Back again just in time for the Holidays. This kit replaces the (5) problematic seals that are the source for annoying leaks in 1962-1965 727 pushbutton transmissions. I have been running this kit in a 727 pushbutton automatic car for over 5 years and 30,000 miles and the driveway is dry and...
DetMatt,
Thanks for the extra photos! Wanted to confirm that mounting and output gear are the same. Would you accept $120 plus USPS shipping? Also, I'm not sure that what was once grease can be shipped without being cleaned out? I think it falls under "hazardous materials".
Thanks, again,
Bill
Thank you, All, for the warm welcome. Looking for a 1968 Plymouth Custom Suburban 9-passenger wagon. ANY condition considered. I'll post again on the Wanted page. Again, thanks for the warm welcome, FriendofVirgilC (Bill)
DetMatt,
Ok. Do you mind flipping the motor/trans assy over a shooting a picture of the opposite(gear) side? Thanks for responding, FriendofVirgilC (Bill)
I'm usually hanging out on the FBBO page as FriendofVirgil. I'm looking for a core or a replacement, driver side preferred, but can use a driver or a passenger side to repair mine. Rear door and front door of either side motor housings are interchangeable but they ARE different. These are common...