jmustian's latest activity

  • jmustian
    jmustian reacted to CBODY67's post in the thread AVS help with
    Like
    Like
    .
    Still in the "future project" orientation. Car does not have cruise. No reason that I know of that the existing linkage would not work...
  • jmustian
    jmustian replied to the thread AVS help.
    Well if that gasket is ok then it must be the carb. Did your cruise and throttle cable and kick down hook up ok to the avs2?
  • jmustian
    jmustian replied to the thread AVS help.
    Well not sure if it's the thick gasket or not. Fsm calls for thin. I can't get full vacuum now to adjust carb. Stumbles and sometimes...
  • jmustian
    jmustian replied to the thread AVS help.
    Think I got a handle on this. I'll post results later. Last spring I replaced the intake gasket with an open crossover tube. Didn't...
  • jmustian
    jmustian replied to the thread AVS help.
    I only have another 1/16" gasket and a 5/16" gasket. Don't think the 5/16" will work with my thermo choke pull off. Gonna call napa...
  • jmustian
    jmustian replied to the thread AVS help.
    • IMG_20250910_141924333_HDR.jpg
    • IMG_20250910_141900792_HDR.jpg
  • jmustian
    jmustian replied to the thread AVS help.
    All the staked caps are tight and dry. I'm gonna try a slightly thicker gasket and drop the floats some.
  • jmustian
    jmustian reacted to CBODY67's post in the thread AVS help with
    Like
    Like
    .
    I don't recall any, but look for drilled passages which are sealed with a ataked-in ball bearing with sealing solder around the bearing...
  • jmustian
    jmustian replied to the thread AVS help.
    Nothing found. Base gasket feels like constantly wet. Not hard and dry. Felpro #1900. About 1/16" thick. Same thing I took off...
  • jmustian
    jmustian replied to the thread AVS help.
    Just pulled carb top again. No leaks spotted. Floats and needles are perfect. Fuel level in bowls are both the same. Intake very...
  • jmustian
    jmustian replied to the thread AVS help.
    If I remember, the needles were solid and the seats had rubber in them. I'll have to look again after Williamsburg show.
  • jmustian
    jmustian replied to the thread AVS help.
    Maybe I damaged needles when adjusting them.
  • jmustian
    jmustian replied to the thread AVS help.
    No. They both were good and didn't fill with gas
  • jmustian
    jmustian posted the thread AVS help in Restoration.
    Cleaned my carter AVS and put in new kit. Followed book and set each item as I went. Vacuum set the idles and runs great. 69 440. Car...
  • jmustian
    jmustian reacted to fyriskung's post in the thread What did you do to your C-body today.... with
    Like
    Like
    .
    It's a nice combination!
Show older items
Back
Top