Recent content by jmustian

Power seats are different

You can only raise it about one inch on the 6 way seat because the bolts are welded on to the seat frame.

My 300 doesn't have that exact light. I have 2 lights with light the dash, supposedly haha

No one has it for less than $100. Everyone else says out of stock. I'm just gonna wire it to my courtesy lights.

I can't find a relay with 2 straight pins and one square pin. So I'm confused. FSM says 2889565 with has 3 standard flat terminals. My Connector, squashed or not doesn't have 3 flat terminals. I just spent 2 hours in the parts manual to see if this connector was for something else and it's...

Manual

Well. Slot is not a full size terminal. It's half size so the relay won't fit. It is the correct number in the parts manual though.

So crushed I had to hot knife it out. Connector was totally crushed inside the plastic. This site has so much knowledge that isn't in any service manual.

Thanks. I ordered on eBay. Napa USA no longer carries that part. My wires were as you described. $32 on eBay.

I have the 69 300, have the dash out, most of the harness exposed and have yet to find a delay unless someone unplugged it and threw it away. My ignition light is good but never comes on. I have what looks like a partially melted 3 prong connector under the dash and connected to nothing. Is...

Oh crap hahaha

I have an AT1 factory tester that appears to work ok. Little rough, missing a knob. $25 and postage. I also have a like new one fully complete for $125.

AMS obsolete found an NOS kit in stock. $89. Cool