MONC440's latest activity

  • MONC440
    I put the UV dye in it and drove it home. After dark I checked it with the UV light and the only evidence of a leak I saw anywhere was...
  • MONC440
    MONC440 reacted to WissaMan's post in the thread Auto Temp 1 to Manual A/C control with
    Like
    Like
    .
    It's a different resistor but I'll probably just use the one that's there. I think on the only difference is it has an extra resistor...
  • MONC440
    The vacuum motors are all the same, you will need a different blower motor resistor I believe. The MyMopar youtube channel has a good...
  • MONC440
    MONC440 replied to the thread aluminum trim restoration.
    What car and wheel moldings are you needing done. My F-I-L says he has a buddy that might have them already done. That guy is also...
  • MONC440
    MONC440 replied to the thread Need help ? 46rh swap.
    It is a pretty good swap into a c-body because you don't have to cut the tunnel. You do have to make a new cross member for the...
  • MONC440
    MONC440 replied to the thread aluminum trim restoration.
    My father in law did trim rehab for years. He does not do it any more but might know someone still in the bis. The aluminum trim is most...
  • MONC440
    I wouldn't vacuum test it I would pressure test the entire system. Normal systems run 12 to 16 PSI depending on your cap. Check what cap...
  • MONC440
    MONC440 replied to the thread Need help ? 46rh swap.
    Do you have pictures of the weights? If it is the big 360 style weight you can cut it off with it still in the car. I did that on my...
  • MONC440
    MONC440 reacted to WissaMan's post in the thread Auto Temp 1 to Manual A/C control with
    Like
    Like
    .
    It sounds like this all worked out for you? I'm 90% sure I'm going to be scrapping the Auto Temp in my 77 and converting to manual and...
  • MONC440
    MONC440 reacted to SludgeWizard's post in the thread Non-running 440 with
    Agree
    Agree
    .
    Yessir good info. The intake, carb and valve covers are all currently off to try and see if the heat blanket ended up anywhere easily...
  • MONC440
    MONC440 replied to the thread Non-running 440.
    Start by visualizing inspecting everything. Then pull all the spark plugs and disconnect the fuel line from the fuel pump. Then see if...
  • MONC440
    MONC440 replied to the thread Engine Advice Needed.
    Maybe but 8.5 to 9.2 is a bit more than half a point. I think the 69 318 was rated at around 200HP and everything after 72 was around...
  • MONC440
    MONC440 replied to the thread Engine Advice Needed.
    That's my point. The 77 318 is going to be less power than the original 69 318 that was IMO already underpowered for our cars. Swapping...
  • MONC440
    MONC440 replied to the thread Engine Advice Needed.
    Now you are talking. You will never regret swapping in a big block.
  • MONC440
    MONC440 replied to the thread Engine Advice Needed.
    Being a 318 car and with your original block already toast I don't see why you would want to wait for a 69 block when you have a good 77...
Back
Top