Recent content by PurpleBeeper

Your basic idea makes sense, but keep in mind that adding an electric pusher fan will help stop/go air flow, but hurt highway air flow. In other words, you might stop overheating in traffic and start overheating on the highway. Here's my 2-cents. 1. Make SURE what temperature you're actually...

There's a company called QA-1 that make a pre-fabricated front suspension for A, B & E-bodies that are tubular and use coil overs. Maybe give them a call?

OK, this might not be "concours correct", but I've run into this problem and this is how I fixed it. "Basically" you turn your distributor clockwise "one spark plug wire's worth on the cap". Then you move each spark plug wire over one spot. Lastly, you re-time the engine since you probably...

413 is correct. On my car (not a C-body, but likely similar), there are two nuts over studs near your knees and bolt down near your left shin that remove the "column support plate" If you remove those 2 nuts and bolt, it will drop down. I also have 4 bolts attaching that support plate to the...

Does anyone recognize this under-hood light or know anything about it? Is it factory or aftermarket? THANKS!

You “might” have the little valve (name?) on top of the steering box off a little. There’s some type of fix where you just loosen it slightly and tap on it moderately so it “re-centers”. Apparently there’s a small fluid hole between the box and that little valve that can get off-center, which...

Good question. They don’t wear out often, but I have had one on a Ford go bad once. Sure, why not replace it? Make sure you get one that’s correctly balanced for your motor (likely neutral balance, but check) You replaced the seal in the timing chain cover where the harmonic balancer goes...

Read the side of the tire itself (very small) and it will list a maximum recommended pressure, and then go a few psi lower. HOWEVER - my guess (14" tires) is that you have "old school style" tires that take a maximum pressure of about 35 psi (similar to factory original tires) & I would suggest...

work great for me

I've been looking into this for a b-body for serval years. The window regulators are different, so you'll need all 4 regulators. The motors are cheap and easily available (eg Autozone). Many people suggest running a relay for each window instead of allowing 12V to go through the switches...

That is a beautiful car

Change the gas completely and put in a new fuel filter. Maybe look at the vacuum line on the distributor advance? Spray some carbuetor cleaner down the air bleeds of the carburetor (500 cfm Holley, right?) I'd start by changing the old gas. Even with stabilizers, it doesn't stay good nearly...

An engine builder once asked me, "How fast do you want to spend?" I will go on the assumption you have a "mid-size" budget and just want a peppier cruiser, so here's my advice. 1. Find a 360 engine. It bolts right in, costs the same to rebuild and starts off with 42 more cubic inches 2. Good...

Geez, I'm not sure if the B-body and C-body collars were the same??? IF they are, you can buy a b-body 4-speed/console automatic shift collar that is smooth all around and doesn't have that column shifter connection. Maybe Tony's Parts? has reproductions or look for a used one. Are C-body...

If you really need quiet, maybe add a set of resonators (glass packs) in the tail pipes behind stock-type mufflers like Hemi cars do. I've been considering this myself