Recent content by Stormrider

Every time I would lower the the top I would be looking for smoke, its a clean way of doing it , time to get some relays and get r done. Thanks again, it put me on the right track.

This is perfect, thank you very much, one relay for up and one for down, clear easy to read and understand. I like the kick panel install instead of at the pump. I really appreciate this.

You guys are are so good, 8-93 there it is , I was looking on 8-127 area going crazy , Q1-12R circuit tap off the ammeter stud that's where that wire goes ! Volksworld that would very nice. Thanks to all.

Hello everyone, is there a wiring diagram for the 68 Sport Fury convertible ? I have not been able to find one, 68 service manual not in the wire section or body, am I missing it. Looking for the switch wiring , It draws a lot and would like to put it on a relay, was looking to see the stock...

413 thanks, looks to be correct. Would these be the same frame as 68 fury? looking to replace the bucket seats in a my 68 sport fury vert , it has 2 driver side seats need a pass side. Thanks again for your help.

Hap thanks for sharing.

Looking to see what these came from, I'm guessing 1967 -69 not sure of a model, driver seat has power, seat back cover same as Fury 68 , any thoughts ?

Thanks Saforwardlook I ended up returning Cardone pump to Classic Industries and purchased A BBB pump from Rock Auto for about the same price. Napa Auto was like a $100 bucks more (crazy).

From what google has to say and we know, not always accurate, Cardone and BBB like to sue each other so there is no relationship. Cardone does make a new pump part# 96-6184 and BBB INDUSTRIES #N7222103. OER appears to be a middle man with marketing NP6157 which can be found on many sites. On...

It looks new, they say its new and I got the one maker I try to avoid. Sounds like it will be ok if its BBB. Classic industries list it as OER pump and several others list the NP6157 with no manufacturer listed. Thanks for the response I was considering returning it.

I know this thread is old, FYI I ordered a NP6157 from classic industries and its a Cardone, not happy about that (see photo).

I have read that zinc additives do not always mix well, as I think Big John had mentioned, best to get it already in the oil. Diesel oil how much detergent is too much?

I found this article sometime back regarding this subject. Best Oil for Classic Cars Good read, I think most of this has already been said but still worth the read. FYI

Thanks 77newyorker440 for your opinion, I thought this would be somewhat of a topic of interest. I read somewhere that with the 12pt bolts you can get to the bolts without removing the rockers but not sure if that applies to Edelbrock rpm heads on a 383. I have a set of eddy’s rpm 84cc from...

Edelbrock Aluminum heads install 383, 12pt or Hex ARP bolts pro and cons ?