Recent content by WOT440

Good point. That being said, the Speedway style trim ring can be purchased individually to minimize the risk.

When pulling dents, rule of thumb...first in last out.

This would be my concern also. Amazon has a good no hassle return policy.

They may not be correct, but they look OK for a driver... and won't break the bank.

I used 2-1/2 Deep on mine. Find them on Amazon. Amazon.com: OxGord Beauty Trim Rings for 15 inch Rally Wheels 2 1/2 inch Deep, Rally Polished Stainless Steel with 360 Degrees Saw Tooth Clip Retention : Automotive Amazon.com: Speedway Motors Stainless Steel Beauty Rings for 15 Inch GM Rally...

No worries. Lmk, if you happen to find them. Thx.

Hello, I'm looking for the two plastic filler pieces, between the dash and the body. one RH and one LH. Please LMK if you can help. Thanks.

At cold start, try cranking the engine 10-20 sec. without pumping the accelerator, to give the bowl a chance to fill, then attempt to start with a couple pumps. Nice Fury BTW.

Diamond in the ruff. :wideyed:

Image

There are clips at the bottom and screws inside the sail panel towards the rear. Be gentle removing the sail panel. Very easily cracked.

Not 100% sure, as it comes and goes. I did notice the RH exhaust shield is loose in the rear...so that will need some looking into. Also, the fuel injectors on these engines are known to be noisy at times. Thanks for your input.

That's great. I appreciate the input. I'll be doing an oil change with 10W-30 Penzoil Platinum full synthetic this weekend as well as some other maintenance. Until then it is parked. Thanks.

Thank you, I just watched that video this afternoon. It was a 2022 Ram with 5K on it.

Interesting.