Search results for query: *

Hoffmeisters.......Imperial Heaven. They have a website. Google search for link.

I have a 67 300 convertible that I would like to customize a bit. Like the 68 grill look better. Is this an easy swap? Thanks

I am trying to accumulate parts needed to add power vents to my 1965 New Yorker Wagon. I have an opportunity to purchase vent motor brackets off 1965 Imperial. Any one know, or have interchange manual, saying wether imperial vent brackets will fit on New Yorker?

Hi .....I got 5 power vent window motors part number 2428282 and 2428283. Wanted to see if these are good for 1965/66 New Yorker (I am restoring a 65 NYer wagon wanna add power vents). Any advice appreciated.

Mopar NOS wind deflector—rare option. In original mopar box. Instructions included. All hardware present. Located in Raleigh North Carolina. $400 +shipping (best offer).

need cruise setup need trunk release setup how much + shipping NC, USA

Ebay.

This gentleman number is 919-675-4021 and prefers text

Increase you life insurance policy, your family may need it.

Looking to install a cruise unit onto a 65 NYer wagon. I found some cruise parts listed for 1966 Chrysler. Might these be the same. I know the dash contour and layouts are same.

? layer fiberglass both side then Dremel out slot for clip

I could use the door panels if you can ship them

Thinking to restore a 1960 Imperial coupe. It has some rust passenger quarter panel up to about 6 inches. I think 1960-63 would work. Source would be appreciated. Car is loaded to the max worth restoring. Arthur in NC

These cars are notoriously unreliable. I think you should flip it. I'll unburden you.

I have a cruise control set up I am going to install in my 62. I see in manual the dial cruise adjuster goes next to ignition switch. Where do I then relocate the power antenna switch? How do I locate the cruise brackets on inner fender well? In my 65 NYer there were dimples where to drill...

I am likely going to buy a 1960 imperial to restore. Bottom 6 inches of behind the rear wheel quarters are rusty. Is that area the same on 60 as 61-63?

Installed trunk release in my 62 but not sure what amp fuse I should use. I bought the trunk release setup from a parts yard many years ago. I was going to hook power up to accessory slot on fuse box but not sure of amperage of fuse to use.

I have a nice 62 coupe and several cruise setups. I have multiple mounting brackets and not sure which is for 62. Also, several control units. Any advice how to install and which brackets appreciated. 919-630-0158

I have a 65 NYer wagon. The dash switch raises and lowers tail gate window fine. Key at rear tail gate only lowers. Is that standard or should I look to replace the switch? Thanks. Also.......how do I remove the glass pane to get to the rear of the switch? Thanks again.