Search results for query: *

I’ve bought a few sets of wedge heads (Indy and Trick Flow), they always end up double boxed and bagged, and arrive with no damage.

I think I have both sides, I will look

I got a set fifteen years ago, came to me just fine.

Hello from Minnesota. Share some pictures of your car!

Thanks very much. Have to get used to the American web-format. Ads seem to be everywhere. Have to find out how the web-page works. There are very few Mopars in Denmark - probably much more in Sweden - so having access to spares and good advice makes it quite a chore to keep the '65 Custom...

#1 cam bearing looks bad but will work perfectly. Check very closely the cam bearing further back with several holes is lined up properly. Was a cam installed, and did it turn smoothly?

Join me in welcoming @Moparviking to FCBO.

Welcome

Welcome

Found mine. Passenger side is good the driver side someone put screws in it

I thought about doing that. The issue was there wasn't a lot of material to wrap around the panel, so adding any foam might make that even worse.

What are they? for the people , like me?

i will try to send a picture of the clips.

This is the one I sold 5 years ago and it’s definitely worth looking at. It is priced very fairly! 1967 Chrysler Chrysler Imperial Crown coupe

You might indeed have a poor electrical connection. You may try to duplicate the issue by wiggling harnesses. Maybe a poor ground?

Hey Cartel, I’ve talked to a few Engine builders and they said perfect cam bearing alignment is desirable but the 75% that is open like yours is totally acceptable and okay. There will be plenty of oil pressure and flow. As far as the lifter bores, did you pay to have them honed? If not, they...

I don't think it's cutting out completely but it's hard to tell as its comes and goes pretty quickly. It feels more like the normal amount of throttle just isn't there. I was able to pull into a side road the first time. Engine was still running and after pulling over I was able to drive away...

I'd lean towards the carb tuning or a vacuum leak. Would you say that your pedal position is just barely cracked? Maybe it's oscillating between transition points (not sure if I'm saying that right). I could also be full of poop. Just trying to throw some ideas out there.

Join me in welcoming @Leviathan to FCBO.

I used 3 or 4 screws & nuts and then taped the seam between the metal and the new masonite. Also added a thin layer of foam to help smooth out that seam.