Search results for query: *

Wondering if I can pick y'alls brain, on an eddy 1406. Carb is fairly new. On top of a 440 in the D300. Truck runs good. Starts up easy, idles good, and don't notice any bogging. Drives good with easy throttle. Problem is, after getting on it, the carb starts to flood out, and run like crap...

I know this was brought up many times before. But ofcoarse can't find it... What was that stuff you guys were using to seal valve cover gaskets on a 440? Engine pookey??? Can someone send me a link? Had no success with rtv. Those exhaust manifolds cook the stuff to nothing, then start leaking...

what are y'all running for mufflers?? Trying to pick out a set. No flowmasters for me. Also not really digging the dynomax turbos either. Being a c body, not looking for loud per say. But deff something with a little growl to it. I'm leaning towards the high flow hemi muffler from accurate ltd...

I'm having a bit of a hard time with my pulley alignment with the new sanden compressor, and federal steering pump. Do you guys see a problem with running it this way? The rear crank pulley grove lines up with the alt. and compressor as it should. The 2nd up crank groove lines up with the alt...

Looking to pull my 360 out of the Monaco. Picking up a cherry picker this week. Anyone pull an engine before? Any precautions? I'm thinking drop the t bars, and possibly deflate the tires. I'm mostly worried about clearing the header panel/core support. Think I'll be good? Was gonna use a...

The 400 in the cordoba has me stumped. The engine will idle/rev fine in park. Usually runs fine in gear when cold. Lately shes been hesitating under a load while in drive. Ill take off from a stop, and it doesn't want to go, but won't stall. Once up to speed, its not as noticible. It normally...

Alright damnit, I'm getting no where finding out info on these clip on speedo gears, except they are impossible to find! (pictured on bottom) So now I'm thinking of converting to the other style gear (pictured on top). Obviously need a new housing, gear, and cable. The car has cruise...

Anyone know where I might be able to find a plastic clip on speedo gear? All I can find is the older style speedo gears, where the speedo cable is screwed on to the housing. Like this- I need this style- (red on pictured) The only place I've been able to find them says they are out of...

Hey guys, Was wondering if any of you have reused a torque convertor in a rebuilt trans? Here's the dilemma... The 727 in the Cordoba works fine, and goes through all gears properly. Previous owner stated it was rebuilt around ten years ago, and according to written down mileage only has...

Getting close to painting my 440 on the engine stand. Was wondering what way you guys think is the best way to paint it? I've seen guys paint them with a brush, spray gun, and aerosol. I'm gonna use Bill hirsh engine paint, and can do any of the above. The engine will be completely assembled.

Last week pulling out of work, the engine cut out on me. Took a minute to get it started back up, but did after a few cranks. Didn't think much of it.. "maybe just flooded out??" Havn't really expeirenced it again the rest of the week (been daily driving the car). Today, again pulling out of...

I took the car out for a little drive today. Was on the way back home, when at a stop light, a guy next to me told me my rear driver side wheel was wobbling. Right after he said that, I had a flashback from a few years ago before the car got put up, of hearing the same thing... So got her home...