Search results for query: *

Any front sway bars? Some station wagons and taxi's had them

As far as I know the Holley Sniper does not use the ballast resistor so you need to tie Ign 1 & 2 (start & run) together to make the system work.

The first order of business would be to mouse proof the garage. If you have mice in your car they are doing way more damage than just chewing the wires. Think pissing in the headliner and heater box. Making a nest out of your seat cushions. Poisoning your lungs with the Hantavirus. You gotta...

If it has been sitting quite a while, I agree with Big John. Probably a plugged sock in the tank. Not sure I understand your comment about the hose in a can. Are you saying you hooked a hose from the fuel pump to a can of gas and still got nothing to the pump? How long did you crank the engine...

Your luck looks to be like mine. I have not tried any of these but you may want to look into finding new cat whiskers here for you Chrysler. Not sure how many are out there for C bodies. 1969 Dodge Polara

Those weather strips are commonly called "cat whiskers". They normally have clips every 4-6". You can try sliding a putty knife or slim tool between the metal strip and door and pry them away from the door. My experience with them has not been great since they break or pull out of the strip...

I'm betting your blower motor is dried out. Running on high will melt the switch contacts in short order.

This Bumper jack was in a 1966 Chrysler Newport that I parted out years ago. It fits Chrysler Newport, New Yorker, Dodge Monaco and Polara except Wagon. It has Hook 2461131 and is complete with Lug wrench and base. The Jack is $75.00 plus shipping. I just shipped a jack last week out east for...

I have a Holley 2bbl that came on a 69 383 Newport. Should bolt right on to your 361. Put an updated kit in it for the dog piss ethanol.

I believe you have some air in the system yet. I have never seen a note saying "do not bench bleed". I can't imagine anyone believing there is a better way even though you can sometimes get by not doing it but IMO it is the best and easiest way. Either way, since you didn't, I would bleed the...

I bought the Top Cat whiskers for my 65 Sport Fury years ago. Both inners and outers. The outers came with the correct mounting clips and the inners came without since they were stapled in from the factory. Other than the clips, the inners look just like the outers.I didn't have the staples or...

Get one of these grommets and install it where the antenna is. That is what everyone does with a car cover. https://www.ebay.com/itm/365390695591

Why do you have to pull the antenna? Where do you put it away?

I hope you meant inch pounds. I never used a torque wrench on any that I have put together.

I have 10-203. $145.00 shipped

I know this is an old thread and I can't say for certain but I believe you can replace the sender and or seal without dropping the tank. Have you tried that?

Back off the adjuster on the right side axle a few turns and try it again.

Welcome from Wisconsin!

Welcome from Wisconsin!

Looks to be a Pioneer model. Most Pioneers didn't have the fender spears or the gravel guards. Is it a 318 2 bbl? It has the same high end mirrors as my 60 Phoenix does. Not many of those left since they were the first unibody cars with no rustproofing. Most rusted out in the first few years.