Search results for query: *

Your rear gear ratio is 2.71. The 4 32 is most likely a date

Welcome

Welcome

Its the drive on the dist itself thats different, most use a hex of different sizes, of course Mopar has for the best description like a tang/flag looking end. The tachs are all the same hex from the ones I have had. MP, SW Moroso The MP electronic is a great unit, really fast curve and of...

Interesting. "Big rigs" of the sky. Notice something though. The Antonov (casualty of Ukraine/Russia war. so its gone :() and the Boeing are older designs with six and four engines, respectively. The Airbus, a relatively newer design, gets the job done with only TWO engines. Their...

Reviving this thread 'cuz more info...from what I can tell judging by the pics on both their site and what saylor and others have uploaded, ECI seems to use the Centric/FVP 12162025 rotors for the 1979-1981 Pontiac Firebird. These are the rear rotors, and of the selection that rockauto offers...

For my '67 300, I ordered the following from DMT: https://www.detroitmuscletechnologies.com/mopar-c-body-65-68-chrysler-a-arm-splash-shield-set/ They matched the originals well. The two big pieces fit over the upper control arm, and the two smaller pieces fit around the front sway bar. Hope...

That is not a functional mechanical tach drive unit. It is missing the tack drive internals : / Buyer beware If I was going to run a tach drive distributor I'd pick up an aluminum DC rb tach drive distributor and run the spacer. It's easier to work on the engine with a little extra clearance...

There is a Mallory tach drive dist. on Ebay that fits low block engines. It needs some rebuilding but looks like it could be made to work. Getting a cable to fit it might be a challenge.

The wheel itself would not go on over the axle flange that sticks out; even without the center cap installed. I did not have any road wheel centers to try using with that wheel. Since the wheels had to go to the machine shop anyway, I had the Cragar center caps dialed in so they are a push fit...

(2.71?)

I'll try to get into my parts storage boxes this weekend while out working on the car and PM you, I'm 99.9% sure I still have one in great shape

Thought I would share my latest trial mod in case anyone else has thought about something similar. Getting ready to drop my stroker motor in that has a Holley TB fuel injection. I know hood clearance may be an issue so I wanted to move my air intake away from the hood and limit clearance...

Here is 5/16th McMaster-Carr

I paid someone else to do it. I wanted to oven cure the coating before putting it on and did not have anyplace big enough to do that myself. No primer is needed but its crucial to do the prep properly. Since the manifolds were already ran previously the powder coating place off gassed them...

Yes mine has on it 2.17 then under that it has 4 32

Sold for $4000. Hope that's not right. Otherwise, somebody stole it. 1972 Chrysler New Yorker | eBay

As long as the holes for the shaft arent worn they look fine. I had some thst were badly worn and that was a "clickedy clacky" nightmare haha