Search results for query: *

Even more impressive when you factor in that when actually measured, that 8.2:1 advertised CR is closer to 7.5:1. If you are "tight" on funds, a hone, re-ring and bearings with a new timing chain and valve job, can get you almost as good as new for not a lot. Using a good double roller timing...

In a full manual valvebody with no low band apply function, this is true. If the trans is still fully automatic, or it has a manual valvebody with low band apply, you start in 1, which applies the band in addition to the sprag and then shift to 2 and 3, if the combo has enough steam to maintain...

Missboxed Powerglide shifter? Kevin

The reason for 15w40 is it's a HD diesel oil and still has an acceptable level of zinc and phosphorus that flat tappet cams need. Regular 10w30 passenger car oils don't have enough anymore. It will pump just fine. Kevin

It might have explained the red engine. Kevin

Any chance that car was built in Windsor Ontario? Kevin

The short bar thing I believe is Plymouth only.. Kevin

Well, I could be a company driver I suppose, but I make a piss poor employee. Lol. Truck spec has changed. 18 speed instead of a 13 now. Kevin

And made it all the way to Helena MT. Transmission go boom. At least I was able to make it to the top of the mountain and into a big enough pull out to get it off the road. It still would drive so I limped back down the hill into Helena, but the noises coming out of the trans told me it was...

I met a guy at Moparfest years ago that had redone the woodgrain on a 72 Sport Suburban and he said you couldn't order the original pattern for a 72, but one of the Chrysler Minivan woodgrains was identical. Of course I've forgotten what year, but late 80's early 90's given it was at least 15...

99 W900L. 3406E Cat, 500hp 1850 ft/lbs torque. 13 speed, 3.90 rears on 12r22.5 rubber. Kevin

The blade is 250'. 303' overall, bumper to tip. Kevin

Just out in the Idaho wilderness getting ready to go supertruckin'. Kevin

Why are you ordering paint from the US? Find a Carquest, Napa or similar near you that sells autobody supplies. Kevin

Cam and pistons are specific to the Poly short block. Everything else is the same as an LA. You can get over 400 cubes out of a Poly with a 318/340 stroker crank and a custom piston. I've heard that Diamond would allow up to 2 changes to a shelf stocking piston for a small fee. Gary Pavlovich...

Is that console a factory option or was it added? Kevin

You should be able to use the later single diaphragm from a Fusey if you have a console shift. Because it's bigger in diameter, it's a no go on column shift cars because it interferes with the shift linkage. Should be easier to find too. Kevin

Solenoid or the drive itself sticking? Kevin

I'm pretty sure they are doing the pre 73 rotors in unicast now but you would want to verify that the part in the box is actually the small bearing rotor and not a misboxed 73. I think the grease seal is smaller on the pre 73 so that would be the easiest tell. Kevin

Did it have A/C originally?