Search results for query: *

Power seats are different

You can only raise it about one inch on the 6 way seat because the bolts are welded on to the seat frame.

My 300 doesn't have that exact light. I have 2 lights with light the dash, supposedly haha

No one has it for less than $100. Everyone else says out of stock. I'm just gonna wire it to my courtesy lights.

I can't find a relay with 2 straight pins and one square pin. So I'm confused. FSM says 2889565 with has 3 standard flat terminals. My Connector, squashed or not doesn't have 3 flat terminals. I just spent 2 hours in the parts manual to see if this connector was for something else and it's...

Manual

Well. Slot is not a full size terminal. It's half size so the relay won't fit. It is the correct number in the parts manual though.

So crushed I had to hot knife it out. Connector was totally crushed inside the plastic. This site has so much knowledge that isn't in any service manual.

Thanks. I ordered on eBay. Napa USA no longer carries that part. My wires were as you described. $32 on eBay.

I have the 69 300, have the dash out, most of the harness exposed and have yet to find a delay unless someone unplugged it and threw it away. My ignition light is good but never comes on. I have what looks like a partially melted 3 prong connector under the dash and connected to nothing. Is...

Oh crap hahaha

I have an AT1 factory tester that appears to work ok. Little rough, missing a knob. $25 and postage. I also have a like new one fully complete for $125.

AMS obsolete found an NOS kit in stock. $89. Cool

I'll check on that. All I have is two leads and no thermistor

Does anyone have experience with an in car sensor. Apparently was on AT1 systems. Two wires are connected to the air tube from the aspirator. It looked like a fragile heat affected wire across the tube and connected to the wires, one on each side. I couldn't find it online yet and part...

Want to get rid of your AT1 parts? Give me a shout

Square holes are there to access screws that hold instrument cluster in place

I ordered one off eBay that's supposed to replace the foot. Since the spacing only needs to be about a 1/16 I might could add some solder if the repro don't work.