Search results for query: *

1965 Chrysler New Yorker for sale by owner - Greenwich, CT - craigslist This would make someone a good starter car!!!!!

My brother in law called on this car. The guy claims it was never driven in salt. He is 2nd owner. It seems like a decent deal. I was going to go look at it Friday but he backed out. Divorce proceedings have started and he figures he should not buy anything until it is through. I would be...

I recently changed my steering box out with a stage 1 firm feel box. To me, the steering feels" rubbery". It is definitely stiffer. In fact, when at idle and the car in park, it is a struggle to turn the wheel. After install I turned the wheels side to side to purge the air. I also aligned the...

I started to change the steering box today on my 1968 New Yorker and have run into a snag right off the bat. I cannot get the roll pin out of the steering coupler. 2 hours of beat, heat and even attempted to drill it with no movement at all. Is there room enough on the mounting stud to slide the...

1974 chrysler imperial Lebaron for sale by owner - Oak Creek, WI - craigslist

1969 plymouth fury for sale by owner - Springvale, ME - craigslist I am tempted. Someone else please buy it so I dont have too

I am getting a bit of extended crank on hot soak on my 68 NY'er. I have wrapped the fuel line in insulation and it helps a bit but i was going to try to install the WIX 33040 vapor return filter. My question to those that have done this, how did you run the vapor return line? Is there an...

Pulled the plugs out of my 68 New Yorker to check. 440 TNT. I got it out of storage 2 weeks ago. I have driven it @ 50 miles since. This is after 4 cold starts without letting it completely warm up. ( moving in/out of garage ) Car runs well. I have tuned the carb using a vacuum gauge. @ 15...

the trip meter on my 68 New Yorker does not work properly. I can reset it and it will not flip over to 10, it will keep rolling on 9.9 miles. SOMETIMES it will go to 19.9 miles but will not flip over to 20. I would like to fix this but I am not sure what I am looking for as far as a cause. on...

I am getting ready to order a replacement steering box for my 68 New Yorker. I have read a lot about both companies just curious if there is any more comments. I was leaning towards Steer&Gear modern feel box.

So, this spring I saw an old friend and we were talking cars when I showed him my 68 New Yorker. He told me about a guy next town over whom had a Chrysler stash. Yesterday was a nice day for a cruise so I took the New Yorker , picked my buddy up and we went to find this guy. We pulled in the...

When I bought my 68 New Yorker, the previous owner said he repaired the driver's window motor. After only one day of ownership, the window no longer worked. Luckily, he had drilled the door for easy access to the bolts. I found the gear stripped of all its teeth and repaired it using this kit...

I went to take my 68 New Yorker for a ride yesterday and discovered brake fluid coming out or the right caliper upper inside piston. I could see the leak when moving the piston manually on the bench. The P.O. had installed new front rotors and ( I assume reman) calipers before I purchased the...

I am removing the aftermarket deep transmission pan from my 68 New Yorker and reinstalling the stock pan. The filter has a filter extension on it to set it deeper in the pan. When removing the extension for the stock pan, is there a plate, gasket or stand-off required to mount the filter in the...

As I was changing my shift shaft seal on my 68 New Yorker, I noticed the linkage bushing on the transmission was kind of janky. I looked one up, $34 for a plastic bushing? I didn't have a lot to do today and had some oil impregnated bronze I had used to make some bushings for an older...

I recently did a distributor rebuild on my 68 Chrysler 440 TNT. New bushings, new/used shaft and a Pertronix ignitor and Pertronix coil. Ballast resistor bypassed. The car seemed to run "ok" but seemed to be lacking to me. It felt like there was more on the table. The timing was set to the...

Has anyone had any luck in finding the correct wipers for these c-bodies? I am battling Trico over their classic wipers, which apparently only come in pin style with a cheezzy bayonet adapter. After multiple call, emails and pictures, no one at Trico seems able to tell me if they still make...

I was having some trouble getting consistent dwell readings and discovered my distributor bushings to be worn out. While waiting for parts I decided to disassemble it. After removing the roll pin for the spacer, I discovered 2 holes in the shaft. Does this look right? Has someone else been...

I am re-installing the a/c system in my 1968 New Yorker. I don't have power going to the compressor clutch with a/c turned on. In my wiring diagram it shows a "time delay relay " between the switch and the clutch. Where is this relay? Can it be bypassed?

I purchased a 1968 New yorker from a member here and the tires are 11 years old. I want to install a set of Magnum 500's. I really would like a set of redline tires for it but the price is making me cringe. Before I spend the money, has anyone here had any experience, good or bad with these...