Search results for query: *

If a car can be grateful, that car has to be grateful to you for saving it from a field. Well done!

Interior and Engine. If Rob sends any more 1994-2000 photos I'll post them

Exterior Rear

Exterior

More Photos from Rob 1994 after purchase from Art's Dodge

Post#1 has wrong information Revised History (@Toolmanmike Is there any way to put a note on post #1 to refer post #307 for corrected history?) *Through a Facebook group for Fury GT owners, I met Rob who is a previous owner of my 1971 Fury GT. I got his phone number through a Facebook message. I...

I did not save the emissions canister, which was a mistake. The original tank was badly dented. I used a 1973 tank and canister.

Fuel Tank

Fuel Lines

I have not been there since last fall. I called Lea. She says it's still ongoing. LMK when you want to cruise in. You can find it on this listing Car Club Council of Central Virginia

Excellent work. Saved to Favorites. Thanks!

I don't think so. The indent goes inside the rotor. I couldn't install the rotor if I had the concave side facing out. Maybe show me a pic of what you are talking about.

Parking Brakes I used 1973 pedal assembly. Same as 71, except I transferred the 1971 release handle Mounting bracket. 2 more bolt holes face driver Clamp at outside of front subframe Cable guard installs in circular clamp Cable comes out at inside of subframe Front cable meets rear...

Rear Brakes LS Adjuster slot plugs installed both sides after final adjust rear brakes

Back to Rear Brakes RS Line attached at wheel cylinder Loctite Rust neutralizer: wet

Axle shafts continued. Install LS RS end play adjusted and set. I use a tiny amount and call it good. 2.76 open rear. 489 case. Don't know if original. Car was picked at over the 41 years off the road before I bought it in 2019.

Axles shafts continued New inner housing seals Install tools RS installed metal gasket metal gasket Brake backing plate installs against metal gasket Foam gasket for axle bearing flange

Back up a step Axle shafts Remove inner seal LS bore and race RS Bearings felt OK. Car was only on the road for 6-7 years Cleaning Grease: needle on gun Needle set

Wheel cylinders I rebuilt both. Pistons Disassembled Original casting # Bore I tried Carquest kit, but did not like the quality. Used Wagner Kit. Brass rings are for a different 15/16 bore application. Recycle them Lube bore with fluid, springs, then rubber cups, pistons, rubber end...

Rear brake lines Hose junction Installed Hose at intermediate line Hose clips Rear brake hose