Search results for query: *

KOOL!

Good thought overall! We are going to start at the cap with a 14 inch drop to a 45% fitting and grade that at 1/4 to the foot. Should have plenty of flow to stop splash back. We modified the stock 70 Charger filler neck tube.

I Would love to talk to this guy!

Hello! Ah the Monaco! Yes right you are on the rust issue. This paint job was done in old barn 1985 "Roadkill Style" We skinned the peeling Vinyl top found extensive rust all around the bottom of it. Used Por-15 on everything! 7 years later blisters started showing up. Yes it go's in the shop...

Hello! Thank you for the insight! My Fitter and I looked at this like a Nuclear install LOL! We plan to run 2 inch Stainless tube and open root Tig weld the joints. We looked at using the existing tank by bobbing the filler neck behind the bumper, under the trunk turn a 90 to the left rear...

Good Morning C-Body Brothers and Sista's! Just received the flip top gas cap parts from Vans Auto LLC. The 1968 Monaco 383 cu in, A-727 TRANS. This was my first resto on my Dads car which hooked me on C-Body's. Runs like a "Raped Ape" For those of you Kat's that dig the Jive! My 67 Polara which...

Hey just a big shout out THANK YOU! to all you guys for your comments and advice. I just turned out the lights in the shop, Tomorrow I'm doing it!!!! LOL!

Hello! I'm a Retired Journeyman Nuclear Steamfitter Weldor LU-598. The repositioning of the gas cap for the Polara is pretty straight forward. Yeah the 16 gal is not acceptable. I might end up modifying the new polara tank by changing the filler neck opening then plumb it to Charger spec's.

Hello fellow C-Body Brothers! Has anyone installed the 1970 Dodge Charger Flip open style Gas Cap, Filler Neck, and Gas Tank on a C-Body Car? I'm looking at doing this on my 1968 Polara Coupe. The tank Swap is what concerns me, mounting points for hangers etc.

Hey thanks guy! I fabbed my rollers out of a lawn Mower Axle! It was the perfect size. Just had to cut to length and drill the Roll Pin Hole. You're a lifesaver. We're all in this together! lol!

Some sick S.O.B. Probably smashed it on purpose! There are a lot of C-body Haters out there!

Yeah I was going to do the same thing, but the Bushings were cheap so I replaced them and went with this Spring. I was concerned I had too much Spring as it was a bear moving it through it's arc,with the Hinge in the Bench Vise but once mounted,those big heavy Coupe Doors didn't even know they...

Sure thing! What's your address?

Hey That makes sense! Thanks!

Drivers! it straddled the steering link

Hello! Well, working under the Engine Bay of my project restoration of a 1968 Polara Coupe. I came across this odd piece of sheetmetal! It's obvious it's part of the Splash Skirting as it had a deteriorated piece of hardened rubber attached to it. So, rolled over to the other side to see what it...