Search results for query: *

  1. jbooth35

    727 damaged line. Which part is this?

    Hey folks, finally got some time to look at the cause of the trans fluid puddling under the car. Seems this line melted again the exhaust. I must have not noticed and forgot to tie it back when replacing the exhaust. Can this part be bought? What options for replacement? 65 Polara...
  2. jbooth35

    Setting timing - erratic vacuum reading

    I’m trying to set up timing and carb using these instructions as they’ve been suggested before and seem solid. Vacuum Engine Timing | MILEPOSTS Garage (Tech Tips) http://tvmoparclub.com/files/tech/Mopar%20Timing.pdf Car seems to drive great but the too lean smell is killing me. I’m using the...
  3. jbooth35

    Oil pump prime failure

    I decided to prime the oil pump tonight since I'm getting ready to fire the engine up for the first time since I've had the car. Engine is a 426 SW in my 65 polara. I began spinning the oil pump counterclockwise and felt nothing for more than a minute. I understand that I should be able to...
  4. jbooth35

    727 filter

    Got this wiX filter from Rock Auto. Pt # 58658, was about to put it on but the original is much bigger. Is there another part number?
  5. jbooth35

    Steering gear removal.

    Need some advise on removing the steering gear on my 65 polara. It is power steering. FSM says to loosen the worm shaft to steering shaft coupling clamp bolt, and then loosen the steering column to instrument panel bracket and pull up on the column assembly until the coupling is clear. I...
  6. jbooth35

    Where do these pins go? 742 SG case

    So, I pulled the center section out of the 65 polara and out came 2 small pins. I honestly don't know where they go, but one fell out onto my chest when I pulled the center section and the other was in the housing. They are small pins with a round head, maybe 3/8 inch or so and not threaded...
Back
Top