Search results for query: *

Good evening and Merry Christmas Eve, I have a 440 i pulled out of my 67 Chrysler 300 and i an not sure it's worth. It has a forged steel crank, "LY" Rods, and 516 heads. The block appears to be in excellent condition and the bores look like they have never been oversized which makes sense...

Good Evening all. This pertains to the 440 in my 67 Chrysler. Stock rebuild with a very mild cam and a msd pro billet distributor and msd box. The short of it is that I have a fuel issue at all speeds where I just seem to run out of fuel in the bowls and the car surges under load. The issue is...

I have under-taken what might be one of the worse ideas I have had in awhile. I have decided to polish the aluminum intake manifold I have had laying around. So far I am aprx 5 hours into the job. I will post my progress as I move along. I may pick up some 440 source heads and polish them as...

Good day everyone. I was home from the middle-east on leave a few months ago and I managed to pull off an engine swap in my 67 Chrysler 300 during that time. My wife was nice enough to give me five days to work on my old junk. It took me three days to complete the rebuild of my transmission and...

Good Evening, Sorry if this is a little long winded. I have been drooling over what to do with my free time (money) when I finally get back state-side. A little back-ground, I have a 1967 Chrysler 300 2 door w/440. I have owned the car for about 3 years and I would really like to re-do the...

This is a long post. I am sure this has been done somewhere before on the internet but I wanted to bounce some of my own ideas off you senior guys who have been around the block once or twice. Goal: I want to build a bulletproof twin turbo 400 that will run on 93 Octane and not blow up...

Good Afternoon FCBO, I was replacing my radiator in my 67' 300 today and I decided to pull off a valve cover and see what the casting numbers on my heads were. I was hoping for the 915 closed chamber heads but that is not what I found. Instead I found the numbers 2406518. I had never seen...

So I went to drive my 67 Chrysler 300 today. I couldn't get it to start. I checked everything with my multimeter and I was getting power to everything. Check. Sprayed some started fluid down the carb. Couldn't get it to fire, not even pop. Not a fuel problem. Check. Pulled the points, they...

I recently purchased my 67 Chrysler 300 and it is in fantastic condition. The only problem i have with the car is that the engine (440) could use a rebuild along with the 727. I was planning on rebuilding the 440 this winter because it is leaking oil. I was thinking of doing the following...