Search results for query: *

What do y'all make of this??? Not a trick. Correct thermostat, used to fit normally. Fits perfectly on cast iron housing. Anybody else see this happen to an aluminum housing from Mancini Racing??

Found a 9.25 axle from a 1978 New Yorker, just wondering if it will interchange with my '66 Polara?

Hey All, Does anyone have, or know where one can find a template for making an oil pan baffle for a stock 699 or similar pan? I'm sure I can make my own from scratch, but I would rather use a template for expediency.

So I'm tearing down an RV 440, 1973 block, 213 heads. I noticed the intake springs are single spring units, but the exhausts are dual springs. Any ideas as to why this was done? Was this a normal thing Chrysler did? I've never seen this before.

So here's the drill: I need to rebuild the 346 heads on the 400 in my Polara, and I have access to a set of 516 heads I can put on the engine as well. I have also added a Performer RPM intake, Holley 600 cfm carb, and a comp 262 lift cam recently. I understand the 516s are closed chamber and I...

I noticed today while I was doing a tune up on the Polara, the engine mount on the driver's side is busted. Engine is a 400, but I'm guessing there's no difference between it and the 383 externally. Can anyone recommend a good mount to use?