Search results for query: *

Looking for an NOS. Which is the correct voltage regulator for my 69 Chrysler 300? with Chrysler built alternator 2098 300 with Chrysler built transistor alternator 2875 400

69 Chrysler 300, headlights are dim, going to replace. If what I have are still original bulbs I'll save them. I can post pics if needed. Low Beams marked - General Electric, Sealed Beam, 2 High Beams marked - Wagner Halogen, 1C1 or ICI (I presume these are most likely replacements.) Thx

1969 Chrysler 300 is lacking the Ignition Switch Light, has been since I bought it. What am I missing? What do I need? Where is this located in the Parts/Electrical Manuals? Thx

69 Chrysler 300, have an intermittent fender indicator. Remove the screw, indicator is loose, but unable to seperate from fender trim and remove. No access from underneath. How does this come apart without breaking it? Thx

Looking for a 69 Chrysler 300 Starter Relay. Started in the Parts Manual where I found 8-52-328 (I presume this is the Starter Relay?). Unfortunately 8-52-328 isn't listed in the 8-52 Page. I then Googled 1969 Chrysler Starter Relays and found two Part Numbers (perhaps there are more?)...

Need some help trouble shooting the gas gauge, 69 Chrysler 300. Not sure if the gauge ever worked, bought the car (needle was on or near Empty), drove it around the block twice and tore the car apart. Fast forward a couple of months, new fuel tank, new fuel sending unit, new fuel lines. I have...

Can someone post a photo of what a 69 Chrysler 300 dome light should look like? Part # or where it is located in the Parts Manual? This is what I have, but I've been told I'm missing a switch. I thought I was just missing part of a removable lense to access the bulb. Not sure what to look for? Thx

69 Chrysler 300, 440/350hp. Decided to go thru the distributor and install a Petronix unit. My problem seems to be the "arm" configuration of the vacuum advance. Original(?)/currently installed vacuum advance has the arm pin facing upward, so the arm runs in between the upper/lower contact...

My Turn Signals flash about 2-3 times per second, seems kind of fast. The Emergency Flashers flash about 1 time per second, seems normal. I believe this is the Turn Signal flasher, is it the correct type? Thx