Search results for query: *

I am in search of a 8 3/4 489 carrier w/ 2.76 ratio. It can be sure grip or open drive.

I am looking for a Carter 4741S core. Thanks in advance for those who respond again.

Iamlooking for a three spd. Wiper motor for a 1970 Chrysler 300

Is there a company that reproduces the pin strips for Hurst 300's.

I am currently restoring a 1970 300 dash and need 4 speedo lens retainers as pictured below. I found many screws and retainers missing from previous work done. Thanks in advance..

AS some of your may know my 300 convertible experience an under hood fire. Quick response kept damage to a minimum. I do need a fan shroud for a 26" radiator, a TNT pie tin, and connectors or pigtails for the following. 2 Wire Temp sender. one wire field connector or pig tail. Alternator is...

I am in much need of body parts for my 1974 Chrysler New Yorker Brougham. Both front fenders are in bad shape and need replaced or repaired. Also need a left front turn signal assemb. Front seat, complete antenna, front windshield, turn signal switch w/ telescopic +tilt wo/ side marker lamps...

I need the interior rear view mirror mount as shown below. The threads are stripped out so it can't be reused.

After replacing the drivers door power window gear I have no oper down, only up. Master switch is the culprit. None on ebay and our member Devlin hasn't responded for the obvious reason as he was a victim of the Campfire's in Cal. Does anyone have one available, doesn't have to be show car...

I need a front side marker lens for my 1969 Chrysler 300 convert. May have been removed from my car at the Duck Run. Was on there when washed and detailed Wed. If there are interchangeable parts and model years let me know. Thanks.

Got my 69 300 back from being painted. Told them to leave the stainless trim and lettering off. Did a nice cut and buff, really brought out the deep shine. The bad news is I am missing the letter H in three hundred. Paint shop doesn't know where it is. Can anyone help am old retired wrench out...

Does anyone have 1969 Chrysler 300 convert. reverse lamp lens or bezel. Had forgotten that the left and right don't match.

I need a source for exterior trim clips. Was removing lower Exterior trim on the drivers side and the trim clips went to pieces. As it now appears. I had better plan on replacing more as the remaining clips look no better. Preparing the car repaint and trim restoration. Photo below shows trim...

Need a good 4166 Hooley carb. No missing parts , just a good core at a reasonable price.

Went to the IMPD Cruisin w/Cops and when to roll up Pass rear and no nothin. Popped out the switch and bypassed the switch and rolled it up. Further investigation revealed bad switch and window mtr. drawing too many amps. Need a switch pwr. window mtr. and arm rest body nut. Still in search...

Need a rust free rt. pass door

Need a rt. rust free pass. door.

need heater box and dash controls for 1969 Chrysler 300 w/ manual a/c. need door pull for drivers side 2dr

Looking for manual a/c heater box and dash controls for 1969 Chrysler 300. also need left door pull strap. Please pm me