Search results for query: *

I am working on the rear quarter window of my 66 Chrysler 300 Convertible and discovered that the power window power cable is just flopping around loose and getting caught in the window roller mechanism. The cable has one of those split bullet type plastic retainers molded onto the cable (see...

I recently purchased a repro 66-69 MOPAR B body center console door to replace the one for my 66 Chrysler 300 console. They are the exact same size and fits perfectly. However, on my console, the center ribbed section has painted black accents between the ribs and on the repro lid the ribs are...

I'm trying to remove the center dash AC outlet. I have removed the flexible duct and the two nuts on both sides of the vent/outlet but it still won't budge. Is there still some other fastener, clip or retainer that has to come off in order to remove this outlet? I can't find anything in the...

Has anyone been able to remove the dash pad from a 65-66 Chrysler without removing the instrument panel? It seems like the dash trim has to come off in order to remove the dash pad.

After removing the front chrome bezel from the console mounted vacuum gauge to clean the glass lens, I found out that there are two gaskets inside that quickly crumbled into pieces after removing the lens. There is a gasket/seal between the chrome bezel and the front face of the glass lens and...

Pulled the exterior door handle off of my 66 300, along with the piece of chrome trim that goes around the door handle and the gasket below the trim piece disintegrated into several pieces. Would anyone know a source or replacement for these?

I removed the clock from my 66 300 to repair it and I noticed that where the light bulb plugs into the back there is a blue plastic filter/lens that has developed lots of bubbles from the heat of the light bulb. I wanted to replaced this bulb filter and wondered if anyone has reproduced these...

I popped the interior door panel off on my 66 300 Convertible this afternoon and noticed that the water shield was missing. Does anybody reproduce these for a 66 C body? Are these just clear plastic or the paper type material. Can anyone post a picture of a door with the water shield still in...