Search results for query: *

We plan to participate in this year's event held by Reynolds Museum. Anybody else going?

Hello all, Have not posted anything here for quite some time - there was not much to report, really. We just drove around without any issues. Did a winter run in December in between big snowstorms before Xmas. Chinook cleaned and dried the roads. So it was still a bit nippy, but dry. Old...

Have to admit - I am close to zero when it comes to older distributors, setting ignition timing and other wizzardry from the era that predates electronic/plug-and-play tech. Now, being in the final stage of my Sniper EFI saga, I encountered a situation when I need somebody fluent in the above...

Ok, I pulled the trigger on the Sniper EFI. Was deciding between the Holley and Edelbrock products. Went with the former because of the cost. Unlike fellow Calgarian Angus66, I aimed at a more complicated scope: engine stays in, all new ignition with time control, the fuel pump in the tank...

Our seatback is far from optimal profile and I am thinking of adding a bit of firmer padding. How to remove the seatback cover (skin)? This is the type of the seat that we have Thank you in advance!

Hello from a classic car Nub. Under a strong urging from my infinitely better half (the plot is similar to one presented here) – alone I would unlikely pull this kind of trigger – we acquired a 1978 Newport hardtop. 400 cid with Lean Burn computer delete; red on red cloth, good set of...