Search results for query: *

  1. Rosco

    Bad Timing Cover Bolts...

    I recently replaced my timing chain and when I went to install the timing cover I realized my bolts all seemed too long- I'd had everything pulled apart for about a year before re-installing the cover again. Some of the bolt ends did look a little rough... I was scrambling with the gasket...
  2. Rosco

    timing chain cover saga, revisited...

    Well, I'm in the process of replacing my timing chain and after removing the cover I realized I had a little hole in the surface behind where the water pump lives. I had that hole repaired but the Hack welder who did the repair for me took it upon himself to grind the excess weld off the mating...
  3. Rosco

    Timing chain cover question

    I was wondering if anyone has an idea of the tolerance for my timing chain cover surface? I have it off the vehicle and had to repair a hole. The weld went onto the flat mating surface of the water pump and was ground off by hand with a handheld grinder. The surface is nowhere near perfect...
  4. Rosco

    Looking for an undercarriage photo

    Does anyone have an undercarriage photo of a '68 Fury showing the oil pan area/front steering components? I have looked online and can't find one. I have the big shop manual and the drawings of the steering linkage aren't great. A photo would be greatly appreciated.
  5. Rosco

    '68 Fury w/318 oil pan gasket- any easy way to do this??

    I am planning to change a leaking oil pan gasket in my 68 Fury. My shop manual says: -remove engine torque converter left housing -remove steering and idle arm ball joints from steering linkage center link -remove exhaust cross-over pipe from exhaust manifolds and leave it hanging without...
Back
Top