finsruskw
Member
I have 100's of them along with 3 4 x 8' display boards.
All are located in Eastern Iowa, 52041
Here are but a few off the tip of my list.
Send me the #'s of what you may be looking for and I'll check to see I have them.
Some I have no clue as to what they are used for.
Your Chrysler FSM's each have a list on needed tools listed at the start of each section
Copied from my Excell spread sheet
Thanks for the ad!
BTW, my beloved Polar Blue 300F has been sold and now resides in NC!
All are located in Eastern Iowa, 52041
Here are but a few off the tip of my list.
Send me the #'s of what you may be looking for and I'll check to see I have them.
Some I have no clue as to what they are used for.
Your Chrysler FSM's each have a list on needed tools listed at the start of each section
Copied from my Excell spread sheet
Thanks for the ad!
BTW, my beloved Polar Blue 300F has been sold and now resides in NC!
| C- 717 | Snap ring installer |
| C-3042 | Htd lifter leakdown test pliers |
| C-3050 | Driver, chain case seal 1956 models |
| C-3051 | Installer, chain case oil seal |
| C-3053 | with SP-1200 & nut, driver & burnisher dist drive sft bushing |
| C-3056 | U joint tool for compressing joint for removal of snap ring |
| C-3057 | |
| C-3108 | Stud, power cylinder remover & installer (steering) |
| C-3178 | Torque converter service tool |
| C-3182 | Torque converter puller tool |
| C-3231 | |
| C-3265 | Fixture |
| C-3284 | |
| C-3287 | |
| C-3392 | Guage, valve stem length |
| C-3556 | Installer, LCA bushing Ply, Do, DeS '57-'66 & Chrysler |
| C-3634 | |
| C-3637 | 60-61 Dart/Lancer w/manual trans |
| C-3640 | Driver, P/S pump shaft seal small tank 58-66 |
