Brad Nelson
Member
Hey all.
So while finally taking the front end apart on my '66 Fury I could finally see the strut rods and noticed a curve in them (picture).
Both sides seem to have a similar bend in them.
It is also very likely this car had some front end damage some time in it's life that might have bent them?
This car isn't going to be a canyon carver, just a cruiser.
Should I just replace the bushings and reuse the original ones or get a set of the Firm Feel HD ones?
ALSO...
If I go with Firm Feel, their web page to use urethane bushings, but I cannot find any sold separately on their site.
Is there another place to look or just go with standard rubber?
TIA
So while finally taking the front end apart on my '66 Fury I could finally see the strut rods and noticed a curve in them (picture).
Both sides seem to have a similar bend in them.
It is also very likely this car had some front end damage some time in it's life that might have bent them?
This car isn't going to be a canyon carver, just a cruiser.
Should I just replace the bushings and reuse the original ones or get a set of the Firm Feel HD ones?
ALSO...
If I go with Firm Feel, their web page to use urethane bushings, but I cannot find any sold separately on their site.
Is there another place to look or just go with standard rubber?
TIA