WANTED 1970 Chrysler 300 parts

[PasiR]

- Both bumpers
- Wheel opening moldings
- Rear window moldings
- Complete tilt steering column
- RH side mirror
- Interior moldings (around windshield and rear glass)
- ETC etc...

Looking for a very good used or restored parts, let me know what you have. I have U.S. shipping address.

Thanks.

 

[Big_John]

Wheel opening moldings

Are impossible to find. If you have some, figure on repairing them.

I did mine by stripping the anodizing off with lye, then repairing any dings, and then buffing. Since there's no anodizing, you have to keep them polished after, but mine were done over 10 years ago and still look good.

 

[Fireflite56]

Try emailing Murray Park. He may have most of what you need and he ships worldwide. www.cbodies.com

I concur with the wheel lip molding statement above. You also could have them re-anodized as there are places that will do that, but you would need a super nice set without corrosion to start with.

 

[ayilar]

@PasiR -- here are a number of members from Finland on the forum. Have you reached out to them?

Paging @Kaim @330dTA @ImpJay for possible suggestions

 

[PasiR]

Good information everybody, thanks! My first C-body build, so a bit challenging...

Pasi

 

[jim almond]

- Both bumpers
- Wheel opening moldings
- Rear window moldings
- Complete tilt steering column
- RH side mirror
- Interior moldings (around windshield and rear glass)
- ETC etc...

Looking for a very good used or restored parts, let me know what you have. I have U.S. shipping address.

Thanks.

I might be buying another parts car, a 70 300 convertible. ill check bumpers and wheel moldings, rh mirror and interior trim, and let you know. im in central CA, if its got a tilt column i think id want to keep that, not easy to find

 

[ayilar]

I might be buying another parts car, a 70 300 convertible. ill check bumpers and wheel moldings, rh mirror and interior trim, and let you know. im in central CA, if its got a tilt column i think id want to keep that, not easy to find

If/when you do, I'd love to see the VIN and fender tag.

 

[azblackhemi]

A buddy is parting a 70 Newport. I'll try to get over there tomorrow and see about the parts you listed.

 

[PasiR]

I might be buying another parts car, a 70 300 convertible. ill check bumpers and wheel moldings, rh mirror and interior trim, and let you know. im in central CA, if its got a tilt column i think id want to keep that, not easy to find

Jim, PM sent.