mr gtx's latest activity
-
mr gtx replied to the thread 440 TNT rebuild.I have no problem with 911 and 520 lift and 6000 rpms. 925 too little 111 lbs seat pressure and too much open at 388 lbs -
mr gtx replied to the thread WANTED looking for a 1962 Chrysler..What do you think 75,000 for the rag top ?
-
mr gtx replied to the thread WANTED looking for a 1962 Chrysler..Yes thanks I looked all over. Nothing good I was hoping one of the board members was ready to sell.
-
mr gtx replied to the thread WANTED looking for a 1962 Chrysler..been checking there.
-
wanted a 1962 Chrysler in good to excellent condition. would really want a 300H or 300 but any model I will consider.
-
mr gtx replied to the thread 440 TNT rebuild.comp 911-16 are not really double springs. they have a damper just like the factory put in their higher performance engines. 911 should...
-
mr gtx replied to the thread 440 TNT rebuild.don't forget only 2.94 gears. LOL
-
mr gtx replied to the thread 440 TNT rebuild.I apologize. you are right after looking back one of my blocks was 10.725. pistons could be as much as 91 thousand in the hole. I had...
-
You can use steel shim gasket as the factory or MLS makes thin gaskets. They cost a bit more than the standard felpro rebuilder gaskets...
-
mr gtx replied to the thread 440 TNT rebuild.no figures are in stone. every block even side to side or from front to back, pin height and rod lengths vary.
-
mr gtx replied to the thread 440 TNT rebuild.why are you using a .051 head gasket ?
-
mr gtx replied to the thread 440 TNT rebuild.close chamber heads are the way to go if you want the right deck height and compression. otherwise you would need dome pistons or step...
-
mr gtx replied to the thread 440 TNT rebuild.pin height is 1.991 for 65-67 so the most it could be is .091 in the hole. the 1967 engines I tore apart were at 75-85 thousand in the...
-
mr gtx replied to the thread 440 TNT rebuild.lets say if you have zero deck height and .039 gasket what is your quench difference between a closed or open chamber head. both would...
-
mr gtx replied to the thread Preference for Edlebrock or Holley?.so does Uncle Tony. lol