Search results for query: *

new at this. thinking adjust the pass side for perfect toe then if the wheel is off adjust both evenly in opposite directions.

Its not a panic. Will standby. Thank you.

toe is perfect now 3/32 toe in.

really 3/4 degrees to match the other side. drivers side is 0.3 negative and pass side is 1.2 negative like to move the pass to 0.5 negative

Is toe perfect now, or off a bit. Moving the eccentrics will move toe, but how much? And will it move it wrong way or the right way? Is steering wheel centered now or off a bit? Moving toe on one wheel can make the steering wheel not straight. That's why both sides are adjustable.

Looks great! Perhaps you could get them cleaned, taped, shot, and touched-up as more of an assembly line production of sorts? Take care, CBODY678

nice job, looks like you had nice centers to begin with

I have no idea how mild or wild your cam is....but I would NOT use lighter springs for the first couple hundred miles...20 min break in at a certain RPM, ok...but unless you intend to idle around town you need the proper spring rate or the lifter's gonna launch off the lobe and slam back down...

Do the camber change, then drive the car and see if the steering wheel is still centered as the car drives down a flat roadway. THEN tweak the toe-in total, but probably biasing it toward the side the camber was changed on. Why the need for the camber change? Just curious. Personally, I...

PM sent

Many people only use the outer springs (of the "dual springs") to do cam break-in with. Yet in prior times, I never read of doing such, unless it was a very picky builder. I remember reading that the original 440 6bbl cam was a "low taper" cam, to allow for great spring pressures. Matching...

I buffed the wheel covers to a mirror finish and moved forward to repaint the black ring around the center cover and silver between the “spokes” that give the wheel cover a perception of depth. I went to the local auto paint supply store and got some masking tape that worked wonderfully since...

Recently I went through the Cool "Car Art" Illustrations thread looking at pictures that may be locatable and saved a bunch. First up doesn't have much to go on but is a real place, the detail in the picture seamed more photograph than illustration so it seamed plausible to locate. This is in...

Also use a good quality break in oil like Brad Penn/ Penn Grade or Driven by Joe Gibs, 30 weight break in. Make sure all is ready for starting right away. If the car was running well before engine removed use all the old stuff to restart the fresh engine. Carb, ignition etc, all must be known to...

You can check the taper on the cam lobes with a dial caliper and check the base of the lifters for crown with a pocket ruler. If you see something suspect, don't use it. And like @Cartel mentioned, easy on the springs during break in and watch the video he posted. I like to ball hone the lifter...

I admire your concern over all things large and small but you're seriously overthinking this .

A lot of the rebuilds I've seen have the seal with no boot. I've always thought the one with the boot would be better at keeping junk out of the rear bearing, but who knows... It probably doesn't make much difference.

need to move the camber 1/2 degree positive on one side only. i know i will get more toe out with that wheel after the adjustment. can i adjust the toe just in that wheel to get the right toe in back with out touching the other wheel ?