Search results for query: *

That is worn..get some of this stuff and put a thin film on the cam when you replace the points...

Looks like some one was able to recover at least one car from the Andrea Doria...

The rod that the spring is attached to also rides the adjustment cam. Return spring tension stays the same as the cam adjusts the rest position of the shoe

Thanks again Tim!! Had a great time as always.

Here a few more...call or email these folks if you can't see what you need on their sites. Mopar Classic Parts - Chrysler, Dodge, Plymouth, Desoto 1935-71 Home - Antiquemopar.com Classic Car Parts –...

Talk with these folks. Lots of N.O.S. Vintage Power Wagons - 1939-71 2WD & 4X4 Dodge Truck Parts & Info

Knauz Motors in Lake Forest, Illinois.

Ground for horn???

Big M Automotive

Could relays be used to supply power to the resistor block? One relay for each speed, and the fan still draws directly from the resistors. Fan switch controls relays only instead of full motor amps.

F/S beautiful 1956 Chrysler 2 door Windsor show quality paint & uphol.

I worked on that car right before you bought it. Young friend found it somewhere and asked for my help to get it running and safe to drive. Small world sometimes.....

Was it wearing the flat wheel covers along with a big dent in the bottom of the gas tank?

Wyatt, when and from where did you get the '78 LeBaron??

Great job as always Tim!!!! Thank you!!!!!!:thumbsup:

Check similar year Daytona (Pacifica and Shelby Z). Rear discs were offered and Shelby usually repurposed existing parts if possible. Bad news is rockauto did not even have listings for rear calipers, although they did show some rebuild kits. Beat up the innernet and see if you can find a local...

I believe that the generator also acts as a starter for the stop/go feature.

Coil overheated. Break out the meter and check everything in the ignition circuit.

Any one here know if the bolt holes in the head are blind or open to the water jacket? I've got one with coolant leaking seemingly from the deck/head, but the lower part of the manifold flange is stained along with one of the bolt heads. I rather not try to loosen anything without knowing if...