Search results for query: *

TTI always wants the casting numbers from the exhaust manifolds. That should eliminate problems like that as I assume they have correct patterns for the head pipes based on the numbers.

How did you search? In the part-number search yea I can plug in "set7" and see the timken show up, but how do you search for bearings based on size or based on axle (8.75) ? What about this part (axle shaft retainer / clip) MOTIVE GEAR 3833322: Where does it go? No kits as far as I can...

This is my 55k mile survivor original. 426, 4sp

The problem with Rock Auto and many others is the listings aren't as complete as they should be. I looked up '67 Monaco (IIRC) and here's a screen shot. No Timkin bearing listed. Yet we know that there's a Timkin bearing set that fits and RA does carry it. I did a little more searching...

The EFW N-20 Aiguillon (Stinger) was Switzerland's first indigenous jet fighter project, developed by the Swiss Federal Aircraft Factory after World War II. It featured a unique tailless design with four turbofan engines buried in a swept delta wing and was intended to carry a detachable weapons...

no need to get to anywhere close to 1000rpm on a reasonably stock engine, period. In the old repair manuals (when cams were milder than in the 1970s), the "aim" was 18" Hg at hot base idle. Of course, when the rpm was increased a bit and ign timing increased, it would go up toward 20" Hg...

There are 4 main other fora that I search to learn as much as I can before asking @david hill for his always generous help: https://buickforums.com/forums/forums/buick-roadmaster-forum.22/ https://forums.aaca.org/...

Yes, searching that forum should be very helpful. Several of the members there are knowledgeable and willing to share their knowledge. @david hill knows these cars inside out, and he fixed an issue with the A/C on Betsy. I am paging him because no good deed of his goes unpunished :)

Thanks for the lead on the long roof forum! I’m chasing an odd issue with the HVAC system in our Roadmaster…

Bump

@DocMcNeedy @3175375 @amazinblue82 Here’s Betsy, my dark cherry 1996 RMW. I acquired her just 3 years ago from New England and have traced her history. I’ve put almost 20k miles on the car since then. She has visited 18 states, DC, and Ontario (Canada). @david hill helped me bring her back to a...

Did you tie the crank and run wires together? If you don't get full battery voltage while cranking, You won't have spark to start. Jumper the + side of the ballast to battery positive and see if it starts. Check your install instructions carefully. What is the resistance reading of your ballast...

N.O.S. 1972 Newport front grille inner right and left moulding Part number #3442799 & #3442800 Condition is very nice with one having small stuff $175 USD + shipping

Does that work for you?

hey @ayilar? ever seen one of these?:poke: