Search results for query: *

Well couldn't find a fuse box connector yet. Fuse box looks good but connector on back has couple burnt ,melted connectors. Might can repair them.

My fsm does not say what size fusible link I should have which isn't there.do you know?

Guess that's the next route. Fuse box is melted at Alt and starter, so have to replace box. Here's a pic of battery and relay where I was cleaning up wiring. Battery has 3 wires instead of 1 and relay has extra wiring at double feed.

Ticked again but lights quit. One feed dead. Neutral switch dead, one feed dead. Temp light switch stuck in cold, regardless of new switch and wire seems ok. Numerous other ground issues. Fuse box was burnt out on starter circuit and alternator circuit so both have been bypassed. Checked...

I think I fixed the issue. Poor dash ground. But I ran out of gas hahaha

Same as instructions stated.

I didn't take the volt regulator off the dash. I hooked directly into wiring from float to gauge.

Gas guage goes up while driving and down while idling. Dash resistor? Gas gauge? ground issue? New sender, new meter match.

Wish we had a menards

Thanks. I've replaced most sensors and controls and rebuilt the AC compressor and put in a new fan. My thoughts appear to be the main controller. I'll be working on it this winter. If I can't make it work, I'm gonna try and create something to bypass that controller. Probably a waste of...

Does anyone know offhand if the 70 New Yorker had the same auto temp as the 69 300. I have a new Yorker available for parts from a friend if the parts are the same, specifically the control box in the kick panel. I haven't seen it yet to know if the temp rheostat is the same.

Thanks. I have the resin and stuff and only 1 good one so I'm gonna give it a try haha

Mine have a different pattern. I can find hundreds for dodge pick ups but they're too big . These are 3.24 x 1.3.

Resins

I'm hoping. May have to try different reasons but I'll keep everything posted

I have 10 originals in various states of broken haha

I'm going to try casting them. It takes 18 of them and casting is usually stronger than printing

6002611. No parts available world wide. Been searching for 3 years. Gonna try cast some

I would have loved to at least meet in Culpepper but my baby is apart right now. Started my winter repair projects on her. Maybe next time. Thanks

That's cool. I'm staying original though thanks