Search results for query: *

If all of your brake lights are on all of the time, then your brake light switch is likely bad. Unplug the wire to the switch which is located on the brake pedal assembly by the pivot point and don’t drive the car until you get a new switch.

Paul, A fuel cell is not going to be cheaper once you figure in the cost for fuel lines, fitting and hold down straps. The reproduction C Body fuel tanks are good quality tanks at a reasonable price. Price a tank on Van's Auto. My 2 cents is that a fuel tank is safer and that there is a...

LOL!

Search Parts

The headlamp bezels that you think are 1968’s are for a 1967 Fury and they are missing black paint in the indentations. GLWS

Awesome!

14.4 volts is normal after starting the car at 11.9 volts. Keep in mind that a fully charged battery should be in the mid 13 volt range.

One opinion is not to use it as it breaks down at high temps. My transmission guy recommends using the latest Dextron Transmission Fluid.

After you drove the car with the pedal going soft, did you check the master cylinder fluid level? Are sure that there isn't a leak somewhere? Was the master cylinder a new unit or a rebuilt/remanufactured unit?

Scott, Are you looking for the moldings that go between the windshield and the A Pillars? Is your car a 2 door hardtop, a 2 door fast top or a convertible? The fast top uses different (shorter) moldings. Do you have part numbers?

The sockets should be the same for any 1968 Mopar. Try eBay. Maybe these: MOPAR 1968 CHRYSLER FRONT SIDE MARKER LIGHTs NEWPORT NEW YORKER 300 | eBay

I have an NOS Mopar manual to power brake conversion assembly that I believe is for a 1967 - 1968 C Body. This is an entirely under the hood assembly that has a master cylinder, brake booster and an adapter bracket that pushes the booster away from the firewall so you don’t have to change your...

I have an NOS '68 Fury right side fender that needs a little work (bent by the A pillar location and a shallow dent). $400.00. You would have to make arrangements for someone to pick it up in North Carolina near Charlotte. Which engine do you need a throttle cable for? Do you know the...

I should have an older remanufactured RV2 Compressor for you car. I also have some NOS and used '68 Fury parts but probably nothing that is wago specific. I'm less than a half hour west of I-77.

I hope that this helps. Raybestos Application: Raybestos R-Line #7018R Brake Rotor & Hub Assy Fits what vehicles: 1971 Chrysler 300, 1972-1973 Chrysler New Yorker, 1972-1973 Chrysler Newport, 1972-1973 Chrysler Town & Country, 1972-1973 Dodge Monaco, 1972-1973 Dodge Polara, 1973 Plymouth...

If you need an NOS center link #2269393, PM me.

@billyfury

I purchased a quarter panel from them many years ago and other items since. They are good to deal with.

The exception is 67 & 68 fast top models, which use a different (shorter) windshield than hardtop’s or sedan/wagon windshields.

On Furys it must be from a 2 door hardtop, “23” body, not from a formal roof 2 door Fury.