1965 Fury right rocker panel pentastar emblem.

[65furyrewind]

How does this emblem attach. If it’s held by a trim nut, how do you access it?

 

[Xcudame]

Usually there's a panel inside the wheel housing of the fender that when removed will allow access to the nut holding the pentastar on. See photo below of pentastar.

 

[Sixpactogo]

Nothing on the rocker panel. Here is a pic of the location on my 65. As was mentioned. the inner fender has to come out or the fender needs to come off unless you grind off the studs and glue it on.

 

[65furyrewind]

My bad on calling the location to be on the rocker panel. The car was painted before I got it and the holes are there for the emblem on the lower right fender. (One main and one smaller to keep it indexed). The outer fender liner is currently removed and so far I’ve seen no access to the back. I will likely just glue it in.

 

[65furyrewind]

Also Sixpactogo, that’s a really sharp looking Sport Fury.

 

[Sixpactogo]

My bad on calling the location to be on the rocker panel. The car was painted before I got it and the holes are there for the emblem on the lower right fender. (One main and one smaller to keep it indexed). The outer fender liner is currently removed and so far I’ve seen no access to the back. I will likely just glue it in.

Pretty sure you can reach in there to install the nut with that outer liner out. Way better than glue.