SOLD 1970-71 dual exhaust tip hangers

Status
Not open for further replies.
Joined
Nov 7, 2021
Messages
69
Reaction score
160
Location
Rainy most days
Feedback: 2 / 0 / 0
Contact seller
Handcrafted reproduction 1970-71 dual exhaust tip hangers. These hangers are patterned from an original and are exact in all dimensions and fit. These are hand cut, hand bent, and assembled by me. They are made to mimic the appearance of NOS which are extremely hard to find in any condition. Correct NOS rubber inserts, correct 14 gauge mild steel, and correct mill finish/patina is present. $400.00 per pair plus shipping.

F42EDD62-0034-4764-96B8-FBFBF10FA252.jpeg
 
One of the best quality of reproduction parts made that I’ve ever seen. These are not “off shore” junk.

Made by hand.

Made in USA

Made by MoPar enthusiast for MoPar enthusiast.

You simply cannot make something like this “with a vice and a mallet”. I’ve seen these parts and I was very, very impressed with the construction.

I had attempted to make my own at one point, but I’m buying a pair of these instead; much less hassle.
 
Last edited:
Adding a couple pics to show everyone the construction. A single pair takes about 22 hours of very intensive and tedious work. I only have a few sets with NOS inserts. If there is interest, I can build more but they will have NORS/reproduction inserts.

667D71C6-35B0-4893-A141-EAFB55C6565C.jpeg


0E4368F3-79D1-4528-8669-CDDD93233A78.jpeg


CE2A1AB8-CCE3-4FBD-A330-FF18098B5EF8.jpeg
 
Very well done and much needed C-body part to be reproduced!! Should be a hot seller with the 300 Hurst crowd.

I was very fortunate to aquire an NOS pair for my SFGT back in October otherwise I would be ordering a set right now.

20211017_213444.jpg
 
Status
Not open for further replies.
Back
Top