67-300 bumper

[mrs49]

Anyone know if any other Chrysler models share the same rear bumper as the 67-300. Thanks

 

[bigmoparjeff]

That's simple.

None.

You'll need some luck finding one.

Keep in mind that a bumper replater can straighten a pretty bad bumper if needed.

They can also patch rust.

Jeff

 

[mrs49]

That's simple.

None.

You'll need some luck finding one.

Keep in mind that a bumper replater can straighten a pretty bad bumper if needed.

They can also patch rust.

Jeff

 

[mrs49]

thanks

 

[pomonamissel]

its 67 300 only . there is one in a yard about 80 miles from me , he won't ship it . but i'm planning a trip to mich to drop off and pickup a car . are you close ?

 

[CBODY67]

Too much trouble to crate, at what expense, and then it might still get bent!

CBODY67

 

[mrs49]

its 67 300 only . there is one in a yard about 80 miles from me , he won't ship it . but i'm planning a trip to mich to drop off and pickup a car . are you close ?

about 60 miles south of Atlanta, not so close

 

[Hubie]

I did see one on Ebay for $2200. You can pay a lot for crating and insurance to equal that.

 

[pomonamissel]

nope its 80 miles north of me in san jose ca .

 

[mrs49]

nope its 80 miles north of me in san jose ca .

Thanks everyone didn't realize I was looking for hen's teeth. Bumper is not bent bad, (never get by the folks on this site) I'll see about getting it straightened. Anyone know of a plater near Atlanta?

 

[bigmoparjeff]

Tri-City Plating Co. Inc.

 

[mrs49]

Tri-City Plating Co. Inc.

Thanks.