Axle info needed

[Fury Rookie]

I was on dr diff site and it shows axles for a body and b body and e body. It also lists custom axles including same length and length for drivers side being 3/8 inch longer. Are any of these for 68 Plymouth Fury 3? As always any help is greatly appreciated
Thanx Frank

 

[CBODY67]

Which engine and transmission? Have you done the visual identification of what you have?

CBODY67

 

[MoPar~Man]

Have a look at this:

Moparts on the Web - Main Index

Another list here:

RWD axle widths and interchange

www.allpar.com

And see also this thread (references the above allpar page):

Rear axle interchange question

I would like to replace the rear axle housing etc on my '62 300. This year was still a "full size" vs "C body" will a '65 C body and later housing fit?

www.forcbodiesonly.com

 

[Big_John]

I was on dr diff site and it shows axles for a body and b body and e body. It also lists custom axles including same length and length for drivers side being 3/8 inch longer. Are any of these for 68 Plymouth Fury 3? As always any help is greatly appreciated
Thanx Frank

The best and really the only way to positively determine your axle length is with a tape measure and your old axle. In reading in one of your other threads, it appears you already have the axle out anyway.

Don't depend on any charts or anything like that you find online. They are often wrong, especially with C-Body specs. My advice is not to spend a single dime until you do this.

Once you've measured, you may be able to buy a used axle or for that matter, an entire rear end cheaper than a new axle, but that's your choice.

 

[1971 300 Alvah]

Call Dr Diff. I found them (Cass? can't remember) super knowledgeable and helpful. He knew what I needed, and helped me verify it was correct before ordering.

 

[Sixpactogo]

I have both axles and rear drums from a 66 Fury. PM me with any interest.

 

[cudamark]

I was on dr diff site and it shows axles for a body and b body and e body. It also lists custom axles including same length and length for drivers side being 3/8 inch longer. Are any of these for 68 Plymouth Fury 3? As always any help is greatly appreciated
Thanx Frank

Assuming you have a stock 8 3/4 rear end, the axle shaft is the same as '65-9 C-body, '65-70 A100, and all E-bodies with an 8 3/4. RH and LH axle shafts are the same.... just bearing retainers and wheel studs are different.

 

[Fury Rookie]

I have both axles and rear drums from a 66 Fury. PM me with any interest.

I have both axles and rear drums from a 66 Fury. PM me with any interest.

Would they be same as forv68

 

[Sixpactogo]

Would they be same as forv68

They are 30" long. Same as all C body Dodge, Plymouth, Chrysler 65-69. Both the same except for the right side axle has the adjuster for end play. Right side has the 5 studs with right hand threads while the left side has 5 left hand threads. I can get pictures if needed. They have been in my loft since the mid 1980's.