WANTED Electronic distributor T bar

[spitfire]

Hi.
Looking for FACTORY distributor T bar which need a spring clip to remove inside.

Thanks!

 

[Toolmanmike]

@halifaxhops has them.

 

[halifaxhops]

I have advance cams and clips what do you need? Advance cam or clip? They usually do not go bad the upper dist shaft bends. Also what number? 17 is 34 at the crank

 

[spitfire]

I have advance cams and clips what do you need? Advance cam or clip? They usually do not go bad the upper dist shaft bends. Also what number? 17 is 34 at the crank

I Can't send pm for you some reason...
I Want to convert my '68 383 point distributor to electronic one,i have an aftermarket 440 electronic one but some reason can't set the timing properly,i think the weights or springs doesn't match and the shaft and T bar different i can't make a good one of them.Can you confirm are those factory dist. parts interchangeable?

 

[halifaxhops]

You have to clean out your inbox. My parts are all mopar oem used or new. Can you call the USA? Much easier. Converting it is a pia. You have to notch the housing. Much easier and cheaper to put a petronix unit in there.

 

[spitfire]

You have to clean out your inbox. My parts are all mopar oem used or new. Can you call the USA? Much easier. Converting it is a pia. You have to notch the housing. Much easier and cheaper to put a petronix unit in there.

Yes i can call you if i can get your number.

 

[halifaxhops]

Clean out a space in your inbox I will send it to you

 

[halifaxhops]

Sent the number