Emblem clip/Grommet?

[Jengel451]

67 Fury, for the front Fender "Fury III" emblems, where is a good source for the round hole grommet/Clip thingies that the emblem presses into?

 

[Stargazer]

Maybe this shop?

B-12967

 

[Jengel451]

Will surf that site a bit.

Not the treaded ones. Needs to be a slip type.

 

[bronze turbine]

I think what you need are called speed nuts, they're self threading, made out of sheet metal.

 

[MrMoparCHP]

Might be barrel clips


Alan

 

[Jengel451]

I think what you need are called speed nuts, they're self threading, made out of sheet metal.

No. The original panel had sleeves. The emblems pry off without access behind it.

 

[Jengel451]

Might be barrel clips


Alan

That rings a bell!

 

[FURYGT]

They are white plastic barrel shaped clips.

 

[Jengel451]

Found them!

Emblem & Trim Retainers For 62 & Up Mopar A/B/C/E Body (25 Pk) #12 | eBay