Moving foward...Engine time!

[64gmc]

Just a little update.

Matt looks like the main cap will work. Still have to have it line bored yet but they look pretty close from what i've been told. Thanks again.

Got a new Edelbrock intake for the beast. And bought all the parts to go through the 4 speed and and rebuild it with a new case. Got that stuff from Brewer's performance. Still need a few big parts HEI dist (don't want to mess with points) and a clutch.

 

[64gmc]

I do need to get back started on the car but it's cold here when i get off work. lol and the garage isn't heated at all! But when i can i'll start removing the gas tank and get it clean and checked for leaks. New fuel lines ran. Clean and under coat the bottom of the car after ixing the rust in the trunk. 6x2 inch spot. And if i get that far start find parts to get dics brakes up front and run all new lines for them. Don't think i'll do much to rear end yet but will be gone through before on the road.

I want to get the drive train in and running, brakes on and done before i start much body work.