Oil Pressure Gauge Sender

[live4theking]

So, I went to install the sender for the oil pressure gauge that I bought, Bosch FST 8202.

The dang thing is too fat, the diameter is just over 2". Would a sender from an OEM gauge (such as a Standard Motor Products PS 59) run the gauge?

This is very annoying.

 

[66Newyorker]

A few fitting and a 4" npt nipple, you can get it up by the back of the intake.

 

[live4theking]

I just picked up a 4" nipple and coupler this morning at Home Depot.

 

[66Newyorker]

Make sure you use teflon tape or thread sealer before you install the nipple in the block and on all the fittings. Post a picture when you get it done.

 

[live4theking]

Everything is tefloned. I'll have to remember the camera tomorrow.