Spark Plug Wires, Who's/What's your prefered or favorite brands?

[70NPORT]

I've burnt the crap out of the rear two boots (#7 & #8) from getting to close to the exhaust flanges...they're burned and cracked. Thinking about doing the "straight" boots this go around rather than the "L" shaped Accel 8.0mm wires I have now. Do the straight boots hold up longer?

 

[1978 NYB]

I use the Mopar factory orange wires. Easily found on partsvoice.com

http://www.partsvoice.com/

 

[thrashingcows]

I went all Accel last time. Tan cap and rotor, and Accel black 8.8 wires. I'm very happy with them.

I too was cooking the rear wires due to the HP manifolds. So I decided to buy four of those header socks.

Been working great for the last couple years. Bit of a paint to get them in and over the 90* boots, but once on they stay put and protect things from the heat.

 

[BillGrissom]

I use whatever is cheapest on rockauto, as long as silicone since it handles the heat and less likely to crack. I have an older electronic ignition (Crane XR700), so may go to 8 mm wires if I upgrade to HEI ignition.

 

[Mr C]

Yes, the straight boots last longer...that's why the factory used them instead of the 90 degree on the rear plug wires.

All my 440's have straight boots on #7 & #8 with no issues.

 

[commando1]

Packard 440 cable with Rajah terminals.