Search results for query: *

I really like this engine :) fired up immediately even beside the fact the carb was empty. I heard no blow by in the exhaust or carb while giving 100psi+ to the cylinders to hold the valves up. Great!

Hello! Thank you for the quick reply. This is for my cousin Vinny . No joke. How much you asking for the different parts? Could you send me a photo of each steering wheel, please, so I can show him. Vinny

Great idea. Could save a life.

1966 Monaco

Join me in welcoming @jmac to FCBO.

Ok I'm putting pistons in and did one side. rod number 1-3-5-7 I snugged up the caps as I went but not full torque yet. everything is turning smooth. I got number 2 in and snugged it and it was harder to turn. I went 1 turn and notice I put the cap on backwards ffs. I took it off and popped the...

Actually have a green NOS one too. LOL!

I have a NOS one. PM me. Also have NOS horn button and ring. Would prefer to sell as a set.

It seems this is something all of us guys dream about. I know I have been. You mentioned having to apply for a variance. If that is restricting your foot print then go up. I would like to build a a 40 x 32 dutch barn, with heated floors, the walls would probably be 12'. Using 45° rafters...

Kind of strange that the pump rod isn't moving, but sometimes it just is. If you are using an electric pump, you want to put a inertia (crash) switch in the feed for it. They are cheap insurance as it stops the pump if you crash and don't get the ignition turned off. $20-$65 or if you are...

they dont ship to uk

Thanks for the response! I should have mentioned that points have been replaced with pertronix unit. Sputtering happens at stead cruise above 50. Muffler over 30 years old single exhaust. Did not have any issues with 2nd or 1st gear (or reverse). Have new rod/fuel pump. Fuel pressure was 5.5 at...

@'69FuryIIIConvertible I look forward to seeing your progress on the build. You definitely have the acreage to build on with a lot of options. If contemplating some ideas, 12' wall would be the minimum, but 14' would be my choice in case you were to have a taller vehicle on the lift such as a...

When you get the tubes set take pictures prior to concrete and Map out the dimensions and locations on graph paper. That will give you an approximate reference for later if you need to put anchors in.

Must be nice for all of you with your dream shop. I envy your shops. I only have a 2 car garage that I stuff 3 cars into it with all of my tools and equipment to get the jobs done. However, as cramped as it is I have built dozens and dozens of my cars, my buddies cars, restorations, race cars...

Join me in welcoming @warlock to FCBO.

ive been told sedans only are the same

I just built a 30 x 40 pole barn. which made for 3 qty 13x30 stalls; each with a 10 foot wide door. I need every bit of that 10 foot door width for the California mirrors on the pickups. If I would have built the barn a little wider yet for those three stalls, I would have a little more room...

Appreciate it.

Ive Just contacted them a the website say they dont ship to my location (uk) my issues are by the time they've got here with duties they'll most probably be close to $1300 also going to need rotors sooner than later so new pads to i haven't even looked into those properly yet im guessing...