Search results for query: *

How do I check the front u joint to see if it could be causing a vibration? Thanks!

for 57 Plymouth Belvedere Torqeflite Trans mount? Also, looking for a decent priced one? Not $75.!

I'm filled with doubt on whether I'm doing this right to get the percentages between the pressure in and the pressure after leakage. Engine has 1k miles, thanks! . Please help!

For my 57 Belvedere left rear wheel. When I loosen the bleeder the brake releases.

Can someone tell me which one will work for sure please? My car has 5 lugs. Just returned one to Amazon that was junk! I think it's called a tapered shaft drum puller? Also I'd like a wheel cylinder rebuild kit for same wheel, Amazon send me one that looked wrong and with missing pieces...

I haven't done a leak down test because I didn't want to spend the $ yet. I did another compression test DRY then WET and here are the results. Can someone tell me what the numbers mean as this engine has about 1000 miles on it? It looks like a leak down test is next. The vibration is really...

I'd like to hear from anyone who has a Plymouth 301 V8 and has done a compression test on their motor to see an average number? Thanks!

I've had the distributor apart and everything looks great, just checked the wires and plugs, compression is 100psi across the board, carb is rebuilt, looked closely at the distributor cap and it looks new, but still has an erratic miss at cruise or still at 15-2k rpm. Only other clue is the...

Do they deteriorate over time even not used? These are on my 57 Belvedere. What's the official resistance per foot for 7mm Prestosil Class E suppression cable?

Mine are pretty even at 100 psi.

Getting down to the nitty gritty, I can feel the engine strobing. It has about 500 miles on it and there's probably nothing I'm going to do about it, but what do you think it is? I figure it might be something out of balance in the torque converter? It had been sitting 9 years so maybe crud...

Can't seem to find it in this pattern of dots and texture.

Volvo heater valve worked perfectly on my 57 Belvedere and saved me more that half the cost. Thanks 58!

I'm going to install a manual gate valve on one of the heater hoses. Does it matter which one? Red hose or black? What direction does the water flow? flow? See picture and thanks!

Old seat cover, rear seat on my 57 Belvedere, bottom photo, front seat too!

The odd brake noise was actually coming from an air inlet on this booster. Says Bendix Aircraft Corp on it. The inlet has a sort of coarse brill fabric under a screen with a snap ring. The sound would come from it intermittently when at a complete stop. It sounded like metal to metal but...

Brakes are like new but when I get near a stop I get this weird creaking. I thought it might be the hubcaps so I removed them, still there. Seems mostly coming from the front right (pass). I bled the brakes and re-adjusted them thinking one wheel cylinder was hanging up. Still there. Maybe the...

Before I put the new gas tank in I temporarily hooked up what looks to be original sender from where the wire plugs to it under the car and of course grounded it and turned on the key and watched the gauge work from empty to full and around halfway while moving the float arm. I also checked the...

I recently purchased a new tank from Vans and the fuel pickup was a good 1.5" off the tank floor which seemed excessive. I contacted Vans and asked him if that was normal. He said it was but with no explanation of why it was ok. When I asked about running low on fuel much sooner he got nasty...