Mr. Nitro
New Member
I'm old, and old to Mopars, but new to this forum and "C" Bodies. I recently purchased a 1967 Plymouth Fury III one owner car that has been sitting since 1988. This car will be for my wife to drive as I have several other Mopars that I drive. I most likely can help out with A & B body cars, but will need help with the C body. Currently I am in the stripping process and have the interior out, the engine and trany out and front cap off. It will need a trunk floor pan, drivers side floor pan and RH lower quarter panel. All of these pieces I have already. What I could use is a better hood. The original hood skin is really good, but the under bracing has a couple of bad spot including where the drivers side hinge lives. Any help here would be greatly appreciated.
Thanks
Mr. Nitro
Thanks
Mr. Nitro
